PTFE (Poly Tetra Fluoro Ethylene) Tube for 3D Printer; OD : 4 mm, ID : 1.9 mm, Length : 1 Meter (Blue)

After a month of use the tube works well, there is no clogs or deformation.The only problem that came out is when filament is pushed through the bowden tube it jerks on the extruder motor side. But it hasn't burst out or torn in.The quality is good with it's thick inners and filament runs fine through it.It comes long enough for two printers so if one is worn out the other can be used.

Adorable tube does its work, no need to go for some expensive tubes if printing only pla filamentTo avoid blockage, cut the tube properly which is in side hot end & sete-steps properly of extruder.

Purchased for my creality enders 3.The inside dia is around 1.9mm.This tube has higher melting temp, hence will most likely prevents filament clog and extruder slippage. It worked after upgrading from stock PTFE.

The quality was good. Cheap alternative to Capricorn tube which i was using. If wish the manufacturer gives 1.2 meter option as well

Good product

product as specified

NIce PTFE Tube in for the range.It’s not that easy to cut though you’ll need a pipe cutter to cut it clean. But does the Job. Better than my stock Bowden Tube which jam the Pathway

Tube is a little bit thinner than the original ender3 tube and hence doesn’t fit tightly . Very Disappointing . :/