12-Slot Fuse Relay Box,6 Relays Box, 6 ATC/ATO Fuses Holder Block with Fuses Relays and 41pcs Metallic Pins for Automotive and Jeep Boat Car Marine Engine Bay

This fuse box works fine and is actually pretty useful. It has one relay connection that has been superseded by newer relays and is completely useless. It also has no way to simply make a hub for power inside. I also ran out of fuse spots real fast and they only give on one connector each slot and NO extras it seems so be careful.

Seems to be a solid product. Used on a fuel injection swap in a 1984 c10. Terminals seem to be of good quality and snap securely into box. Not sure how weatherproof it is, but the cover snaps on snugly. Also has a bottom cover and nice sized hole to route wires through.

works fine for my needs in my car. not weatherproof or water resistant enough for me. but I will DIY that myself with gasket or silicone? the only connections I recall that are 30amp/10 awg wire compatible are the four connections to one relay for ignition voltage . rails for fuses do not accept 10 awg wires. so I ordered from separate company. I have 12 10awg wires exiting the opening but had to cut and widen the opening to form a larger flap of the pre existing opening . more wires than that and you will need to get a rubber wire boot sleeve to make it water /weather resistant . I went with all independent wires in and out for each fuse . this for me is only 6" from positive battery terminals . individual circuit wires are fine straight to battery in my case . they say its rated at 40 amp , but nothing accepts 10awg wires except 4 terminals intended for a ignition relay

Relays are too wide to fit without trimming down their tabs or deforming the box. Lucky for me but I didn't mess up, but No extra terminals. The bottom cover should be redesigned to allow the wires to egress from a user selected side. The mounting tabs are horrible, no included spacer to compensate for the offset. No o-ring on the top or bottom covers. I ended up just coating all contacts with dielectric grease.The only thing I really liked about it was they have a tab where the wires come out that allow you to zip tie the wires secure.

This was perfect for adding the needed relays to my V6 swapped Civic. Mine came with some extra terminals for the relay slots! I messed up a couple there, so the extras were great! I wish there had been extra terminals for the fuses, though. It can accommodate 5 pin relays, too!

Need directions how to assemble it. No manufacturers name so unable to find directions.

This is a very nice fuse and relay box for the money. It works as it is advertised and all the parts shown were included. I didn’t think it would actually come w the 5 relays but it did include the relays. The bottom area where the wiring goes is a little tight. I only used this box for one fuse and 3 relays. Using it for all 5 relays would require very careful wiring to get it all to fit.

Worked for what I needed to do an ls swapValve is greatWater resistance not so much no rubber to seal the lid not the wires that go to the boxDid not come with the 4 pins hooked together thats my only bad so far that was disappointing to find