CR Laurence Shower Door Translucent Vinyl Bulb Seal with Pre-Applied Tape for 7/32" Gap (1/4" and up Thick Glass)

Remodeled master bath, with hinged shower doors. Despite glass installer putting a shower plastic "sweep" on the bottom of door, it still leaked water around the edges, in a corner, and near the door gap opening. The sweep just smeared water into my bathroom floor when you opened it after a shower, needing floor to be towel dried each time. I used this silicon bubble product with adhesive strip laying it horizontally under the shower door gap, and removed the sweep from the door.. Now, water just flows down the door, and into the shower, not my bathroom area - as the silicone bubble product acts as a dam keeping water on the inside of the shower.

I saw prior reviews commenting on the fact the product is shipped coiled. So upon receipt I unpackaged and placed flat on the floor with some books on top to allow the product to straighten prior to application. The seal went on easy and adhered to the glass door edge.

This product was as advertised, but I had one problem with installation. The product came coiled in a tight loop, to fit into a small plastic bag. The resulting curvature in the seal was a problem, as it caused the the seal to pull away from the bottom end of the door. I started from the top, and the seal adhered well all the way to the bottom. But when I cut off the extra at the bottom, the last few inches curled away from the door, and would not stay adhered. I ended up having to use some additional adhesive glue to get it to stay attached.

I applied the seal to a glass shower door. While it filled the gap between the door and the glass wall the door was attached to, I noticed it started coming off after a couple of days. I reapplied it to the edge of the door and closed the door to hold it in place. that held it on for about another day. I have also tried applying silicone glue to the back and that too came off after a few days. I am not sure if the issue is with the seal or the door itself. That's why I gave them the benefit of the doubt and gave them 3 stars. Given that, make sure the surface you are applying to is very clean before applying. I wiped it down, but probably should have used a solvent such as alcohol first.

The body of the seal was twisted in the middle so after installation it twisted off of the door, it just lifted right off. This also indicates that the adhesive leaves something to desire. I don't recommend it, I need to buy another one but not this particular item.

This replaced the original flapper type of seal. It works better and looks better than the original and I believe it will last much longer.

Applied to the door and it’s already peeling off after just 1 day.

After having installed a few shower door seals in the past, I can say confidentially none of them have ever been as easy to install and nice as this one. Truly one of the best products I've worked with in a while and the perfect size to fit the gap I have. It's also actually clear (not frosted) which is great. Highly recommend. The preapplied tape has been strong as well