Description: Ignition Switch :Thin Red(VCC)/Thin Blue Indicator : Thin red (Indicator power output) /thin black (indicator negative) Brake :thin yellow (Brake signal)/thin black(Negative Power) Speed governor :Thin blue(Speed handlebar Signal input) /Thin black (Negtive Power) /thin red(5V Positive Power) Charge Port : Thin red (charge input power Positive) /thin black (Power negative) Brake Light: Thin red (power Positive) /thin black (Power negative) Specification: Brushed Controller : Size: Size: (Length x Width) 8cm x 6.5cm / 3.1" x 2.6" Motor brushed controller for Electric bicycle & scooter Rated voltage: DC 24V Current limit : 28A Rated power: 500W matching motor: dc brushed motor Under Voltage Protection: 20V Handlebar: Size: (Length x Diameter)10cm x 2cm / 3.9" x 0.8" Electric Bike scooter twist throttle accelerator with power display, 5Led battery indicator. Throttle Works Voltage: DC5V Speed Adjusting Signal:0.8V~4.3V Power display Voltage: DC 24V Power display: Normal: 23V above, 3 Led Green Half: 23V ~ 20V, Led Yellow Empty: 20V or less, Led Red Rotation angle: 0 °~ 70 ° Working temperature: -20 ℃~ +50 ℃ Fits standard 7/8 inches(22.2mm) handle bars Cable length is approximately 59 inches (1.5m) Qty: 2PCS (1 Twist throttle grip and 1 normal grip (matching thumb grip) ) Throttle Wiring Diagram: Red connects to Red ,Voltage 4.3 to 5.0 Volts. Blue connects to Black or Yellow, Ground. Green connects to Green, Blue or White, Speed Adjusting Signal (0.8 to 4.3 Volts). Yellow connects to Power positive, Power display. Package Included: 1 X 24V 500W Motor Brushed Controller 1 X Throttle Grip (With One Normal Grip)
B**L
It works well just with the battery meter was more accurate.
It works.I had to use this on a 2000 ev global ebuke that is 24 vilt witha 250 ratted watt motor.We have put atkead 100 miles on it now with no problems.Only reason it gets 4 stats is the battery guage.It works BUT is not very accurate.See you can be cruising an hour thinking you still have a full battery by the indicator, BUT when you stop and accelerate again All the green bars will disappear and then slowly come back on.The same this when you hit a hill.Si some advice one you get to the point that two of the green bars disappear when you accelerate or go up a hill consider that half battery.If you don't like I found out you will be pedaling a many a mile with a heavy dead bike .One thing you may or may not like is it sti worked when the batteries were very very low Most factory controllers cut the power to keep from messing up the batteries, this does not.Fine if you r using lithium but it's very bad to run a sla battery all the way dead, and a 24 volt bike is normally "low end" and powered by sla batteries.
A**D
Good customer service and good product.
Was worried it wouldn’t work well, but it worked flawlessly, customer service was great too, needed a wiring layout and they emailed me it quickly.
Trustpilot
1 month ago
1 month ago
