Brass Heavy Duty Front Steering Knuckle for 1/10 RC Axial SCX10 II Honcho 90046 48g/pc

Again. Chinese. Spend $20 extra and buy a brand name.First, the outer bearing race is way too big. Will solve this with a couple bearings(that I don’t possess atm) inside bearing fits as it should. And the mounts for the steering rack are pretty tight(do they have part tolerances in China?) whipped out the Dremel. Boom fits now. Designed to work with this companies “kitty patty’s”(Chinese beef patties) they do include two bolt holes for those(which I also bought but can’t install because the wheel hex’s will not protrude enough to bolt my wheels on) but they’re decent as well.

I have purchased this brand before with good luck. I previously got two sets of portal covers for trx4. They were great. I bought 2 sets of these for my kids scx10ii's for Christmas. The install went ok. But the steering arm is longer than a factory axial. So the geometry is wrong now. the tires are noticeably towed in on both trucks. So now i have to get custom with the steering to correct that. I have gotten away with the china stuff mostly. But I wish I would have bought a brand name on this one.

Didn't fit at all. Arms way to shallow to fit onto hub. Also the holes for bearing placement are bored completely different from stock axial scx10 II bearings. Like the other guy said just buy better quality cuz these are garbage. Peace

Bought this for an scx10ii, ar44 axle. One side looked pretty nice and it fit great, while the other had a horrible end mill finnish I immediately noticed ,and that would be okay, but no. Stupid ass bearing holes,( inner and outer) were not concentric to each other rendering them trash out of the box. The axle would not fit through the off-centered hole .Had me pretty mad. I had all my stuff apart and couldn't just fit the part and wasted my money and still need to find some heavy knuckles. I thought they'd be alright by the reviews but be aware !!! There's some poor attention to detail here. And also you will need to debur the crap out of them, their really sharp on all the edges.

These are excellent! No problems on install and no need for new links!However, with the 1.9 Axial beadlocks I'm using, the top rear corner of this knuckle does contact the inner beadlock bolts. Simply filing the corner down or using some extended hubs resolves the issue!

The inside bearing was extremely tight, but was definitely doable. The outside bearing housing was way too large for the bearing to press in safely. The mounts were not direct fit, they have sizable gaps. And although this is not a negative for the seller I would strongly suggest to not over tighten your screws and be weary of how you drive your truck after installing especially if you have plastic axles. I broke my front axle the second run with these installed.

Perfect fit for the Axial SCX10 ii Honcho.*Note: All hardware is included but one screw was just a bit short. The original screw worked fine with the new knuckle.

I had a bad feeling after reading some of the reviews but I went ahead and bought it. After put them on everything went great bearing fit smooth with no play, though they don’t fit as tight as the original plastic knuckles. Other than that good buy.