TECHGEAR [3 Pack] Screen Protectors to fit BlackBerry Key2 [ghostSHIELD Edition] Genuine Reinforced Flexible TPU Screen Protector Guard Covers with Full Screen Coverage inc Curved Screen

Lovely item fits perfectly and goes on smoothly

Los quality plastic film. It's so thin that it's extremely difficult to position and glue it on the screen. If you bend it even a bit (which tends to occur) you'll have to start again.Completely useless product

Covers the screen well - just be patient with the install, follow the instructions properly.

Too fiddly to put on, it was full of bubbles, protector is a bit too thin I feel, couldn't get the bubbles outUpdate:Moving up to 4 stars bubbles went away by themselves, the protector is very non-intrusive you can't even tell it's there don't know if this is a good thing though, but I've used one from this brand before which has stayed on my Key1 for almost 3 years and is still there.

Obviously a review for a Blackberry accessory will be of limited usefulness. This arrived on time, but the instructions warn that failure to use the instructions for application will result in a lot of bubbles. I followed the instructions, and after half an hour, gave up. The protectors I've used previously applied easily and were more rigid.

Best screen protector for Key2

Best for key2 hands down

The screen protector is very similar to a thin sheet of rubber with some adhesive on the reverse.To fit it, you remove the backing sheet and stick it onto your screen, smoothing it out using the included card with a felt cloth edge before wiping it all with the included cloth.However - the backing sheet comes in 2 parts. No 1 is a strip about 15mm deep and runs along the top of the screen protector (it covers the sensors at the top of the screen) and No 2 is the remainder of the screen.Removing No 1, I stuck down the top of the screen protector and it went on well, with the adhesive grabbing onto the screen. I smoothed it down and it was perfect - no bubbles. I then went to remove No 2, but it wouldn't come off the back of the screen protector and I began stretching the rubber, so had to stop.By now, the portion of the screen protector I had stuck down had been pulled away from the screen, so I removed the whole screen protector and laid it down on the table with the back upwards. To remove No 2, I had to hold down the screen protector by putting my finger on the back of the area which I had already peeled off.I didn't peel No 2 completely away - just halfway down and then allowed it to 'spring back' onto the back of the screen protector. I then re-applied the screen protector like I did the first time and it went on and smoothed out well - with the exception of the thin bit above the sensor in the centre of the top of the screen which had, by now, lost its stickiness and, although lays flat, isn't stuck onto the screen. I also had a bubble near to the top of the screen (in the part covered by No 1) which was caused by the laying down and pulling up of the screen protector.So, I've found that if you want to apply this well, you need to:1) Lay the screen protector face down and, holding down No 1 with a finger, pull up No 2, and peel it down to about halfway down the length of the screen protector and release it, allowing it to lay back against the screen protector.2) Clean the screen of the phone.3) Peel off No 1 and, holding the sides of the screen protector in the area of No 2, line up the screen protector with the phone's screen and press down the middle of No 1.4) Using the card with the felt cloth edge (the felt cloth against the screen protector), smooth out the area of No 1.5) Holding the tab for No 2, peel it back and downwards slightly. You can now use the felt cloth card to 'push' the screen protector down onto the screen as you peel down the back of No 2 (holding onto the tab).6) Once the backing sheet is completely away and the screen protector is stuck down, use the card to smooth out any bubbles and ensure the whole screen protector is completely stuck down.7) The included polishing cloth can be used to wipe the screen protector from any dust / grime and ensure a smooth finish is left.All in all, I'm very happy with this protector and only wish someone had told me how to apply this properly in the first place (so it loses a star). However, I do have 2 others in the pack so I intend to replace the one I originally applied when I get the chance.

Hay que ir con mucho cuidado, al milímetro ayudando con la tarjeta que incluye para ir arrastrando que no quede ni una burbuja de aire! A pesar de que da la sensación de estar quedando burbujas, en realidad son de film 3 que se retira al final, luego de haber pegado todo el protector, hay que retirar el 3 cuidadosamente y listo! Pero muy importante es que al retirar el film 1, quede perfectamente alineado para evitar que luego el resto quede torcido! Cubre perfectamente la curva a los lados de la pantalla! Hay que tener paciencia y mucho cuidado! Recomiendo su compra!

A very thin screen protector and is easy to apply, but after a few days the clear screen protector is less transparent, because it becomes greasy in a certain way and therefore has to be cleaned again and again so the price is super. The disadvantage is that it absorbs fat and dirt.

Un peu plus compliqué à poser qu'un film classique ou un verre trempé, mais l'écran du Blackberry key2 étant légèrement incurvé sur les bords, c'est la seule protection a bien épouser les bords et devenir quasiment invisible! A la pose il est reste 3 minuscules bulles d'air sur l'écran, mais on ne les voit pas du tout quand l'écran est allumé. Je conseille de faire la poser après avoir pris sa douche ou un bain bien chaud, la vapeur d'eau ambiante retiendra la poussière. Bref en suivant scrupuleusement les instructions, on obtient un chouette résultat! Je ne mets que 4 étoiles car malgré tout, ce film reste fin et je ne sais pas s'il sera suffisant en cas de choc sur l'écran.

La pellicola in TPU veramente ottima aderisce bene e neanche te ne accorgi che esiste, perché dopo averla applicata si amalgama bene sullo schermo la consiglio

Produit très compliqué à adapter sur le téléphone en tout cas c'est in fine mon avis.