LAGWIUY Universal 2" 52mm Water Temp Gauge Automotive, 100-250℉ Water Tempera...

This temperature gauge went into a '72 Correct Craft Barracuda. The classic design of it is good enough that it blends in completely with all the other gauges. Lookin' good!

Appears accurate and a simple install to replace my failed factory gauge.

I’m not sure. The gauge itself seems very cheaply made—that being said I’m not sure it has an accurate reading. I say this because when the key is turned, the gauge automatically goes up a quarter of the way On the guage. Could be a bad sending unit, I will update if needed.

Good

This temperature gauge was very easy to install in my truck. It is accurate and works very well. I have had it for a couple of months now and have had no problems with it not reading or not working. The only thing is that I did need a couple more adapters in order to install the temperature sending unit.

fast and before it was time .

I got this gauge to use on my old Ferguson 35 tractor, which does not currently have a water temp gauge on it now. Since it will be a while 'till I get it hooked up on my tractor, I decided to test it in the kitchen. I wired it up with a small 12 volt battery and put the sensor into a pot of boiling water and the gauge gave a very close reading to 212 degrees. I am at 3000 ft elevation, so water boils at a lower temperature than at sea level.

I installed this temperature gauge in an older Yamaha Rhino so I can monitor the engine coolant temperature. Installation was simple and the included wiring directions were clear and easy to understand. No wire is included, so you will need some 18-16 gauge wire for 12v power, ground and signal from the temp sensor. There is also a separate connection for the light, but I wired it the the meter power and gnd terminals, so my backlight stays lit anytime the meter is powered. The temp sensor has a standard 1/8 NPT thread. Accuracy appears to be good enough, but I didn't have another meter to compare it against.Overall, this is a functional, basic analog temp gauge that should look right at home in older cars, trucks or other equipment.