SEAWORTHY INNOVATIONS Stern Pad Jumbo White - Screwless Transducer/Acc. Mounting Kit (for Large 3D Scan Transducers) - Made in The USA with Genuine 3M VHB Adhesive

I bought a Garmin Echomap 93sv for my Tahoe. This is my first fish finder and my first boat. I didn't want to drill the hull.So I did some shopping online, and everywhere I looked, I was brought back to this product. Everyone recommended it.Follow the mounting instructions to a T, and you shouldn't have an issue.I did have to cut mine a little b/c of how the rear of my boat is shaped. Even with it cut, it still has an incredible grip on my boat.Yeah, I'd buy it again.

This prevented making mistakes mounting my transducer. Holds strong and looks good.

Arrived early,well packaged,very easy to install,works amazing,made my install of my depth finder on my boat perfect and has held in place every since install, instructions were very helpful and simple to understand.

Installed easy, holds tough. Appears to be made of quality material with 3M adhesive. Clips to hold transducer wire also have adhesive. I installed transducer with no new holes in boat transom!

Worked good for not having to drill holes in the haul of the boat. Had it on for 6 months and holding tight as it was the first day

Have this product on two of my boats and have purchased from this company twice in the past. Pads were all installed at the time of purchase per manufacturers instructions. Just installed a brand new Garmin LVS 34 Livescope Transducer on the port side of my boat and thanks to your product I'm out of $1,200 (The Cost of my Livescope Transducer plus $99.99 stainless transom mount. To say that I am at a loss is an understatement of the year. Had the transducer on my boat four trips this season with no issues at all. Even sealed the edges after install with 100% silicone just as I have done 3 previous pads. I backed off the beach with my stern in over 5 feet of water and thought my lower unit had grenaded itself, nope to my dismay I see my Livescope wire dangling behind the boat and realized my brand new Livesope Tranducer had just gone through the prop. Brand new Yamaha Propeller now has a dent where the tranducer or mount struck it while the motor was in reverse. I know I installed this pad correctly because more than half of the 3M tape is still attached to the boat. This was a complete product failure to say the least! Will be uninstalling all of these pads from both of my boats before I lose another transducer. I'm furious and out of alot of money. Buyer Beware!!!!!!!!, Do not trust this product to keep your transducer safely attached to the boat or risk losing your hard earned money. I had saved up to buy my new transducer and have lost the ability to even use my new Garmin Depthfinder. DO NOT BUY THIS PRODUCT IT WILL NOT HOLD UP

I got this for my brand new Carolina Skiff 192 CC. Did NOT want to drill screw holes in the fiberglass hull so I thought I would try this. It's been on for a couple months now - maybe ten fishing trips - and it still appears to be holding strong. I can detect no weakening of the adhesive at all. The transducer mounted to it is a triple shot unit that sticks out about ten inches. I would buy it again.

The transducer mount is great because it is easy to install and is very secure. I didn’t want to drill holes in my aluminum boat and this is the best way to go