WeatherTechCustom BumperTopper for Honda Pilot - Rear Bumper Protector (BP0070) Black

Fit like a glove and looks like original equipment. The installation tape is a bit tricky but just take your time. It protects the deck nicely. I have tested it by loading some doors in my Pilot. The protection took the hit instead of the paint job. It’s a bit pricey but the fit is perfect and the look is fantastic. Plus, it’s American made which is a nice plus. You get what you pay for. Follow the instructions to the letter!

Fits perfectly - and easy to install. We had some heavy luggage tumble out of the back on a recent trip that put some dings/chips in the edge of the bumper. The bumper topper covered the dings/chips and will provide further protection to the bumper. Wish I had installed it after purchase. Caution: Be very careful when peeling the plastic off the adhesive backing. Slow and steady and you'll have success.

I read thru previous reviews with potential issues with it lifting up on the end and planned accordingly by adding an additional piece of double sided tape, about 1/5” square on both ends. So far I haven’t had any issues and it feels really secure in all places so it may not of been needed. Install steps are straight forward and simple enough. One note, if you follow the companies instructions for removing the adhesive cover I would make sure you have about 2-3” tabs started. If you pull in a continual motion it removes pretty easily but if not it gets tight in some spots and can tear if you don’t have enough of the tab already available. Quality product. It is a bit pricey, think it should be about $10 less but none the less it is getting the job done so far.

Easy to install. Fit perfectly.

Looks nice and is holding up really well!

This fits well but is a little expensive for what it is. Adhesion seems very good and it seems like it will provide good protection. But an important not on that: when you first set it, I recommend that you pull a little more of the backing than what they say and then don't press hard until all the backing is removed. For me, the backing tape broke as I was pulling it off, and I almost could not pull the rest of it off because I had pressed half of it and it was pretty tight. But there was just enough backing tape still sticking out such that I could grab it with needle nose pliers and carefully get the rest of the backing off.

I have purchased many WeatherTech products in the past. This is the first time I was disappointed with the quality of a product. While the installation went well with good fit, alignment and adhesion; after it was installed I noticed light grey/blackish streaks and marks throughout the entire molded part. The marks were worse at the middle and ends. I was expecting a completely black product, not one that appears to have multiple molding colorant defects in it. They are NOT stress marks. At this point it is installed, and removing it is not a good option without destroying it or damaging my Pilot bumper. And I doubt WeatherTech will step up and admit their product is defective and replace it with a properly molded part. It is unfortunate, because I actually like how the product fits well and would look great otherwise. I guess everyone will look at the defects and see the WeatherTech logo prominately stamped into the right end for good advertising. Don't know how this got through manufacturing quality control (US Made Product). Will make me think twice about ordering WeatherTech in the future.

Custom Fit for 2023 - 2025 Honda pilot