Upgraded 316555800 9"/6" Dual Radiant Surface Element, W10823692 Compatible with Frigidaire Kenmore Whirlpool Range Stove, 316418401 10" Heating Element Replace AP4556791, 316418400, DG47-00022A

Bought this to replace a non functional burner on our stove. Came quickly and was easy to install. Works perfectly. Just what we needed to fix our stove.

The surface element that I received was not the one shown in the product pictures. For example, one of the bullet items in the pictures states, "No opening in the center of the frame to reduct heat loss." However, the item I received does have an opening in the center. It actually matched a surface element provided by another vendor on Amazon. However, the power and voltage ratings shown on the box (2400 watts, 240 volts) matched the specs for the desired part (316555800). The resistance values also matched (=~ 45 ohms per element). So I went ahead and installed it, and it seems to work OK with my Frigidaire FEFLMC55FCB range top. Of course I had to stretch one of the wires because the pinout did not match the old surface element. But that was expected.

The product worked perfectly. The 2st tome it was delivered to my backyard tho. I think it was thoughtful to keep anyone from stealing it tho. Appreciated it just the same. I'm always satisfied with Amazon!!!

I got this to replace part # 316418400 for a Kenmore range. While it took me a while to figure it out, now it is working great. Be aware that you cannot connect the wires matching the old one, rather ensure you are connecting to the corresponding terminals. Turn upside down the old element, still with the terminals connected, and new one. On the reverse of white block attached to the element, identify the a1, a2, b1 and b2 terminals. On my old one, a1 and a2 are aligned vertically. On the replacement, a1 and a2 are across. This will save you a lot of time and avoid you guessing what terminals go where. Also take a picture before you disconnect the wires. Good luck!!

well pack, perfect fit and easy to install.

This was a perfect replacement for my burner that didn't work. Two of the terminals have swapped spots from the original, but in the pictures there is a chart with the new lay out. I had to turn the burner slightly so the wires could reach due to the new layout, but that's easy to do. I have a full working stove now.

Something so simple. Part of the burner not working. Inspected it and found the break. Ordered it and replaced it. It was that simple

Replacement original element

Si enciende la resistencia, pero si no tienes conocimiento de electricidad no la podrás hacer funcionar, no trae instrucciones de instalación ni algún tipo de manual, ya que no son idénticas al numero de parte original de tu estufa. Tienes que identificar bien los cables que corresponden y conectarlos donde deben de ir. 1b es el H, 2b es el S, 2a es el 2 y 1a es el P1. Uno de los cables tendrán que hacerlo mas largo.

This is a good replacement compared to other sites that sell 'OEM' for $300. Two terminals are switched but one of the reviewers here already posted a details photo about the change in wiring, so I knew exactly what I was doing. I think I will buy one more just incase my other old one blows.

Burner is working very good it’s right parts