Xbox One Elite Series 2, 2th Gen Controller, 2pcs Replacement Analog Joystick Module 3D Thumbstick

Yes the dreaded stick shift struck, and rather than replace the controller I thought I’d give these a try. If you can use a soldering iron then consider getting these if you have Xbox controllers that are sticking/drifting. Fitted a treat and I have no more problems. Will grab some more for further use if needed.

I've bought others and after instant install they have stick drift from the get go.. these were one of the cheapest I could find and they didn't disappoint they slid straight in nice ends to solder and loaded up the calibration to find stick drift is non existent! Time will tell for duration but perfect off the bat! Cheers

Product worked initially while testing no drift issues however after about 10 minutes of use it started to drift. I changed deadzones up and within an hour of play it's at nearly 30% drift which is utterly terrible. 14 solder connections is quite a lengthy repair as well so sub standard parts have wasted a lot of time and I'll have to repeat it all again. All in all colossal waste of time, money and materials.

Watched a youtube vid on how to replace these and it helped, remember to purchase a solder sucker if you doing this yourself, i did purchase a new controller while i repaired my faulty one, the faulty one is now repaired and works perfect, can’t complain my controller is fixed for under a tenner, take your time and watch the youtube vid..

Fitted great, good quality

I'd bought one from eBay to repair an Elite 2 controller but unfortunately after installation it was showing a completely different drift, more than likely faulty before installing. These however, not only showed no fault after installation but actually required no calibration once installed. Would happy to use again