ATIE2-Port/3-Port Pool Valve Rebuild Complete Kit Compatible with Jandy 2-way/3-way 4715, 4716, 4717 Valve and Gray Valves with Diverter Valve 4720, Cover 4606, Handle 7433 (1 Pack)

My old diverter valve was leaking, replace with this one and it worked as expected, no more leaks. It is running for week, I'll update if anything happens on the upcoming months.

Perfect fit. Not issues.

Good value for the money. Easy to install, and it seems to have fixed a leak in my original valve cover.Remains to be seen how durable it is, since the cover is plastic instead of metal like the original.

Product fit perfectly.

Worked as advertised and easy to install

I used this kit to repair an old Jandy "Gray Valve" Diverter Valve. It restricts water flow out to the pool, so the port to the Polaris 360 Pool Cleaner has enough pressure to work.The Trick to putting it back together:The sliding seal inside my old valve was really worn out, so it was real easy to turn, and was internally leaking.The replacement diverter assembly, being new, has a new sliding seal opposite the handle end, that sticks out. It should, to last. But putting it in as the directions say, didn't work for me. It wasn't centered.Instead:Before taking apart, set the old handle squarely over the word "INLET" marked on the old cover. Note the positioning of the old diverter assembly inside, with respect to the valve body when you take it apart.Lubricate all the new O-rings as directed. Do NOT force the new cover over the new diverter assembly (yet).Take the new diverter assembly by itself, no cover on it, position it such that the keying on the shaft to where the handle will be later, is over where the word "INLET" was when the valve had the old cover on it.You will see that the diverter does not want to be centered, and appears not to fit. This is because of the new strong seal built onto the slider. Keep the diverter in that position anyway. Then put the cover over the diverter in the proper orientation, AND USING THE COVER, pull the cover and diverter assembly in the direction to make all the cover screw holes line up. You are compressing tightly the seal on the new slider. While holding it tightly centered, hand start all the screws. Tighten alternately like lug nuts on a car. Keep holding that cover in position the whole time, until all screws are all tight!DO NOT use the screws to try to center the cover! The valve body plastic plastic was not designed for that kind of force! YOU apply force to center the cover, to compress the sliding seal on the diverter.

I pulled my old handle out that was messed up and was able to install the new one within 5 mins. Worked great no leaks or problems.

Axis was way off center and wiper doesn't fit. Would have returned them but I had to Rob the o rings to get the old valve working.

Need to be more specific on break down diagram, regarding assembly… Do the small “O” rings go on the valve stem during assembly or into stem port in cap. Does it matter.Very happy with the replacement parts.