Searchlight American Diner Bathroom Flush Ceiling Light Brushed Silver Chrome Acid Ribbed Glass 4042

Good value for money, sturdy and we'll made

I brought this light fitting for my sewing room/craft room and put daylight bulbs in so I have good light even when it gets dark. I loved this light that much I brought a second one for my upstairs landing put soft shade bulbs in it .so this light can not just go in a bathroom you can put it anywhere you want to.

Love it! Easy to fit, and good quality.

It gives off so much light. Our preference is to use the warm light rather than the cold harsher light bulbs. We ordered two, one for the bathroom and one for the back porch. They were a good size and covered up where the previous light fitment had been.

Looks good. Easy to install. The only problem I faced was the seal to the glass was stuck in the wrong place. I lifted it and applied silicone to stick it in the right position to make a air tight seal as it was in the bathroom.

I love this product. I bought it for my bathroroom as it have a mixture if old and new look about it. Looks fab just as I hoped it would. I don't know if it was easy to put up as it was installed by an electrician as I'm having by bathroom refurbished.

Just got this delivered today but now light bulbs . What light bulbs so you put in x

I've bought a couple of these in the past, and thought they looked good and were easy to put up. However, the manufacturers have changed the design slightly and it's a right cake and arse party trying to sort it out.The glass on my previous lights has a large circular opaque rubber seal, with a U-shaped cross section - so you slip it over the glass, and press it into the metal plate and tighten it all up - and the rubber seal stays put.But not with this thing, they now have a large circular opaque washer which is held onto the metal plate with a single blob of glue, so once you put the metal plate against the ceiling, the washer hangs down and you then use your third and fourth hands to stretch the washer (which is too small) all the way around the lip of the glass, whilst holding it in place, upside-down.Utter crap, I ended up glueing the washer all the way around and, as I mentioned, it's too small.A real shame, as it looks nice but the earlier models look nicer with the seal evenly around the edge of the glass.