Quick-release molding compound A problem-free molding compound can be removed from an original model by means of the rapid and simple hollow forming (negative forming). This impression compound is completely safe and can also be applied to the skin. Mix the powder with water and pour onto the desired object. A few minutes later, the self-made mold is ready. This hollow mold can be used immediately, e.g. With relief casting compounds. The copy of the original is finished. Processing, mixing ratio: Place the desired impression model in a plastic container. The impression compound is mixed with approx. 23 ° warm water in the ratio 1: 3 (1 part powder and 3 parts water). Rinse thoroughly for 1 minute until a homogeneous mass is formed. The total processing time is 3 minutes after the beginning of the amish process. The demoulding of the object 5 minutes after the start of mixing. Note: The processing and demolding time can be lengthened or shortened by lowering or increasing the water temperature. Cold water gives a longer processing and setting time. Hot water shortens the processing and setting time. The mass is nontoxic and skin-friendly and therefore also suitable for children. It is also suitable for shaping body parts (eg children's hand)
A**N
Good enough
Good enough
G**T
Three Stars
Didn’t dry very fast.
L**Y
Five Stars
Good stuff but you can get it a LOT cheaper elsewhere
J**E
Five Stars
A***
Trustpilot
1 month ago
3 weeks ago