30 Pieces 304 Stainless Steel Metal Business Cards Blank Steel Laser Engraving Stainless Cards for House Office Customer DIY Gift Plate, 86 x 54 mm(0.8mm Thickness)

If you're laser etching, you need a stash of these at all times. You can use them to protect your laser's bed, you can test settings, they make great business cards, excellent for test burns, they are just all around useful. I've even cut out earrings for girls I know out of them. Something to keep in mind is that they are sharp around the edges, so you might need to sand them down if you want to make business cards. I'd pay extra if the maker of these cards could round those edges for me. Also you need to MAKE CERTAIN you remove that plastic film! Just scratch a corner and you should be able to pull up enough to pull the film off easily in one go. Never pay more then 50 cents each for these. You'll be blowing through ALOT of these things!

I love the quality of the cards. I Love the thickness, and smooth feel of the stainless steel, great chrome shine color, also for the value it's my only choice to buy from this supplier. Thanks for always getting my orders right and well worth the money spent! Great Job Thank You

Good quality, each one has a film to avoid scratches. Good for me.

When I first opened the package I was a bit upset and going to leave a bad review. It looked like most of the plates were scratched. It wasn't until I started calibrating my laser on these that I realized they shipped with a plastic coating, and only the coating had the issues. The actual material is great! I got the 0.5mm version and is great for me to do some testing with, but if going to use for business card type of thing, might want a thinner one. I did a 2 pass color test with my fiber laser and couldn't be happier. However, make sure you have a way to clamp it down as the heat from the laser did have it warp a bit that will effect the color output.

Excellent cards, thick, brushed finish on both sides and protective foil on both sides. Very pleased with quality.

I bought these for use with my xtool F1 and found that anything over 55% power when using for heat etching warps the metal at this thickness up to 1/4 inch off of a flat plane. Not sure if that would improve by laying on a wet surface to counter act the warping, or if it will affect the colors the laser produces on the steel. Would recommend a thicker template if you want to use for this purpose. At 90% power the shape you are engraving warps into the metal.

sharp edges

First off, these are NOT .8 mm in thickness nor stainless steel! Not aluminum either, but more likely tin. Very cheap and cannot be used reliably for engraving. Don't waste your money.

I need thick stainless steel plates for my laser engraving business. There were exactly as advertised and fitted my requirements exactly

材質は、ステンレススチール(鉄)では、ありませんでした。

Good quality

The item was delivered on time as described. No complaints here. One side has protective masking which is really good. Will buy again

だまされました。 ステンレスと書いてましたがプラカードでした。 見本の写真とは別物です。