SAE Extension Cable, 2FT 10AWG SAE Battery Connector, Ring Terminal Harness Accessory Cable by MENTBERY

Got this hooked to a LifePO4 battery and it's working as expected. Good construction and high quality. At this point I'm using too many words to say too few things. It's not a complicated item.

Solid cable, easy to install. Value fir the orice

Very nice quality. It is now affix to a Fisker Karma to keep a trickle charge on the starting battery.

heavy duty and good construction

I can't find anything to not like about these. Good quality connections, works well. What else is there to say?

Overall good quality, however, one of the loop ends pulled right off and I needed to redo it with a new one. Otherwise, worked as expected.

No messing around with these big boy battery connectors. They are the real deal, high quality.

This was an upgrade for a much thinner fused SAE cable. This is nice and thick and doesn’t get too hot. I wired it directly to my battery (which happens to be in the trunk of my car) and used it to power an Ecoflow River on a road trip. The Ecoflow was powering a 12v fridge and it kept my Ecoflow charged up without any issues. I cannot stress enough, this did not get too hot, just warm. I had a much thinner SAE cable previously on there and it worked fine for using a trickle charger on my 12v car battery, but anything beyond the trickle charge made the wiring heat up way too much for my comfort. This continuously put out 90-100 watts for 8+ hours at a time and I never had any issues. When I stopped, I’d unplug the SAE cable so I didn’t drain my car battery. It came with a 10 amp fuse installed, I replaced it with a 15 amp fuse to allow the maximum 12V/100 watt input into the Ecoflow without blowing any fuses. Again, it will get warm but the thicker gauge wire handled it just fine for my application.