SAVITA3 Sets Thumb Studs, Titanium Screws Replacement Thumb Studs Pocket Blade Screws for Benchmade 535 Bugout (Silver)

Much smaller than I thought they would be. These would be great on a 1.5 to 2” blade.

Idk what people are complaining about. If you want a good product don’t cheap out!! You get what you pay for. That being said it works perfect as a replacement on my 535. Better to have one then to be missing one. I lost mine in the washer but these replacements do the job.

I used this on a folding Kabar knife that lost its studs. I got it on to stay, but for some reason it won't quite tighten down onto the blade, so it moves a bit. Still works, though, and probably works fine on some other knives.

Didn’t fit the Buck Bantam that I bought them for. Would work on a thinner blade. Seem like good quality, look nice. Bummed they didn’t fit.

3 sets = 3 different thread patterns and bore sized males. the three female sides are the same however and thread on to only one of the 3 male sides. see pics

I was very happy with this purchase. I have a Boker rescue folding knife, and somehow I allowed the thumb studs to get loose and fall out. Needless to say, without the thumb stud it becomes much less useable. These studs worked perfectly and got my knife back up and running.

Super simple install with a Torx bit, pliers, and red Loctite.Perfect fit.

Would work great on a small folder probably best for 3 in and under.

The screws are too short for the thickness of the blades I wanted to apply

Machen was sie sollen

The actual size of the part that fits in the hole is 4mm not 5 as it says in the measurements. And this being the case they are way too small for my knife

What a find i have a few pull open knives or folding knives and these little studs just drill a hole pop the stud in and then screw the other side on and you have a single hand opening knife , wow what find

First off, only one side of these thumb lugs accommodate a torx fastener (T8). Whereas with the original lugs you can use two T6 fasteners to snug the lug tight, here I used a pair of pliers to hold one side down while I tightened the other with a T8 driver.It's also worth noting that the nominal outer diameter is 2.4mm (measured with generic digital calipers so there's probably some error in that number). That's a little bigger than I expected as I was going to use these for a replacement on a non-535 blade.