Jackel Cord Uniseal 2 Inch Hole

I used this product to get my sump pump cable through my sump lid with a good seal. There was an existing plug with two holes that this plug replaced. It fit the existing hole well and created a good seal.

Very high quality, sizing is exact - perfect for the job of routing a Starlink cable through a stucco wall.

Of course it is fits the Jackal products but can be used on other surfaces as well by drilling a proper size hole. I did find something irritating but then if it was not like this - it would nod do as good of a job as it does. That is - it is difficult to drill a hole in as the rubber does its job of being flexible and will likely need a little trimming. Kind of like drilling a hole in Heavy and thick Jello. The other side of this plug has partially drilled out & spaced guide holes for adding additional power cord holes. I drilled out two additional holes for a total of 3 size 16/2 electrical wires and then razor knifed lines between the holes so I could install the wires from the installed slit in the side to the hole shown on the picture. Too bas Jackal does not show you picture of other side as it is VERY INFORMATIVE, I had very little problem of installing the three wires in each of their holes but getting the plug into the Jackal sized hole takes a little work. But then if it did not take this little work, it would not seal as well as it does and tight enough that sealant is likely not needed. By the way it can be removes rather easily but again takes a little work. Flexible as it need to be, good seal, not that hard to work with - dont think you could do any better.

Perfect fit and snuggly holds the cords and seals the 2” hole in the sump tank cover. I had two wires so I just drilled out another hole and cut another slit to slide it in. Now my basement doesn’t smell like crap.

Exactly what I needed for my older sump pump pit with a 2 inch hole to make an tight seal. The hole fit the cord perfectly (there is a slit to allow you to insert the cord into the hole), and the plug itself sealed the lid's hole very well.

Fits perfectly on my lid missing a grommet. Was able to use existing hole for one wire and used a utility to open a second hole for another wire. Would buy this again.

worked perfect for missing part.

Good quality