PLC Controller, DC24V Programmable Logic Controller 4 Channel 100K Pulse 32bit MCU Industrial Control Board with Housing for FX1N-32MT, 16 Point Input 16 Transistor Output

The instruction book (available online) was a good resource for getting started with this controller, but it didn’t get as descriptive as it should have. There was a fair bit of guesswork involved in getting things connected to this and working. If using two power supplies (one for controller and one for the load), make sure you connect the grounds together. The controller will operate from a 12 volt supply, but it will struggle to read any inputs. The software can be found for free, but expect to do some searching.This thing is rugged. It survived a couple of miswires, though I did wire it in a way that I could quickly undo it if it was wrong. The software likes to set the default communication speed to 19.something kbps. Set it to the lower one, even if your adaptor supports the higher speed. The controller itself only supports the slower one.

It doesn't work at all. software can't communicate to the PLC; I try different USB to RS 232 cable converters. try it under windows 10, windows 11, two different computers, change all possible combinations in the port communication and nothing happened, never had access to the PLC. DO NOT WASTE YOUR MONEY.

If you need a work around for this device simply delete the device memory by changing the D valuedint like the fact i had to play with the Gx developer ver8 software for like 2hr's to make it program the plclike the fact for under $200 i got the 20mr and the training software and the 32mr plc... and did not pay +500 to 1000 USD.. LOl be smarter then the tool you work with ... :)

No instructions, no power supply, and software to connect to is outdated but still 500 to 1000 bucks. Scam.