OliYin 10pairs JST-XH 2.54mm 1S 2 Pin Balance Plug Lead Socket Male and Female Connector with 22awg 10cm Silicone Wire Cables

Exactly what I needed to build my speaker based on the Satellite 1 dev kit from Future Proof Homes.

I used this instead of buying the ComfortBilt Pellet Stove thermostat connection wire. In order for this feature to work, your stove must already have the blue 4-wire data cable style electronics. (Cycle through your modes to see if your panel has the 'Thstat' mode available). Follow the manufactures instructions.

I have a Dry Guy Turbo boot dryer that uses a small fan motors in the fan units to dry out my work boots. The bearings inside the fan motors in the dryer housings wear out and need to be replaced periodically. I am using these connectors on the power wires for the fan motors to enable me to quickly and easily swap out a failed fan motor. They are nice and small and will easily fit inside the Turbo dryer housing. They look to be of good quality and they should last me for a long time.

Of all of these type connectors that I have bought, and there have been many, these are the only sets that have the polarity, correct! I also like the fact that on the female connectors, there is reinforcement where the wires go into the housing. In other connectors, the wire always seems to break where it goes into the housing. Buying more to replace the ones that I have previously purchased from other vendors.

Well constructed with a slightly heavier 26 Guage wire as compared to other similar products. Polarity from male to female was correct. Worked great on my electrical project!

These use silicone covered wires and to avoid confusion they use the correct red/black polarity. Used to replace a potentiometer on an SCR voltage regulator circuit board.

Disappointed that on one of the connectors, the red and black wires were reversed. I did not realize this until it was to late. The circuit I was powering with this connector was damaged beyond repair. Lesson learned - check the connectors before using them.

Smooth transaction, fast response to order and delivery, item as pictured and described, A +++

Grabbed these to add two fans and extend the length of another. Nicely pre-tinned and has some good quality silicone.

I am using one of these to wire up a relay for an Arduino board to switch a 120 v water pump on and off. The connector works as advertised.