Moen 7594C Arbor Kitchen-Sink-faucets, Chrome, 0.375

A wonderful upgrade from my old faucet.

Moen and other manufacturers should provide easy-to-use tools to remove old faucets. It took me 3 hours and a lot of hard work to remove the old faucet! Corrosion had built-up on the main threaded piece that held the old faucet in place.Moen did not provide adaptor connections to old supply hoses. I Had to stop installation, run out to the hardware store and purchase two 1/2 inch to 3/8 inch reducing connectors.The new Moen faucet was fairly easy to install except for the annoying trip to the hardware store.Dan M.

Doesnt go back into place all the way. You have to position it back. And there is no obstruction under the sink. Like the on/off handle

I absolutely love this faucet! The pull out hose is great for cleaning fruits and vegetables, washing dishes and cleaning the sink! When you switch from stream to spray, you can adjust how hard the spray is and you can move the faucet head to be as close or as far away as you need it to be. (Keep in mind that the switch from stream to spray is regulated by water pressure. So, you can't turn the water down to a trickle and expect the spray to stay on.) You can have it turned on pretty low though. We have to turn ours on about 1/4" of the way to full open before we can get the spray to stay on. But that is just about perfect for the spray pressure when you want it soft, and it works great!It is very easy to install, looks great, and works great! The reflex works wonderfully. If you need the pull out extension to be short for a single basin sink or long for a deep well double basin sink, it works either way. You decide how long you want it to be. The faucet comes with a weight that you simply clip on the pull out hose under the sink, which determines how far you can pull the faucet out and how far back it reflexes. The only caution I have for you on this is that if your sink plumbing is a mess, like mine, the hose and weight will hang up on it. If you don't fix it, this will render the faucet extension useless. There is an easy fix though! We simply used an old piece of cheap poster board and some painters tape to make a channel along the back wall of the sink cabinet for the weighted hose to slide up and down. By containing it in the makeshift channel, it can't hang up on the other plumbing and it works amazingly.My only other caution is for people who are replacing a 3 hole faucet. This faucet is much shorter than the old faucets were. There is only 3-1/2 to 4" total length on either side from the center hole on the trim kit. So, you can easily change your plumbing set up for a single hole installation, but the trim kit may not cover your old holes. We just used the single hole faucet assembly (without the trim kit). We put it in the hole that was best for reaching both sink basins and then bought 2 cheap 2 inch hole cover blanks to cover the old holes. You can spend $20 or more each for hole cover to match the faucet, but we just used cheap plastic hole covers and it looks fine.We installed one of these for my mom over a year ago. It is still looks and works like new! It was so nice, that when our old faucet crapped out a few months ago, we decided to get this one, too! And as an added bonus, it was actually $50 cheaper than the non-reflex (pull out) version. And it's Moen, so it has a lifetime warranty! Highly recommend!

Overall I like this product. It works and the color is as advertised. But I’m used to better quality with Moen. The weight is properly installed but the pull down doesn’t match flush like my delta did. If you can’t design it so the gap closes at least make the metal inside black