Paint Tank 2L Pneumatic Imitation Stone Paint Pressure Spray Gun Colourful Lacquer Airbrush High-Capacity Pressure Bucket Marble Paint (Caliber Optional)

Description

Specifications: Air pressure: 0.1-0.3 MPa Air consumption: 240 L/min Discharge interface: 1/4 " Intake / outgassing interface: 3/4 " Trachea length: 2M (red) Tube length: 2M (white) Operation Tips: 1. Before using, check whether all parts are intact and whether the valve switch is closed or not. 2. Pour appropriate amount of paint (the amount cannot exceed 3/4 of the tank capacity), and tighten the four butterfly nuts by means of symmetrical tightening(make sure it is the tightest and can’t be tighten any more) 3. The red trachea is connected with the pressure regulating valve and the air inlet of the gun body, and the white material pipe is connected with the paint tank discharge port and the gun body feed connector, and finally the air pump gas source is connected to the pressure regulating valve air inlet. 4. Pull out the pressure regulator valve, clockwise rotation to the required pressure (usually 1.5-2.5 kg pressure can be used), counterclockwise rotation is decompression, after adjusting it should be pushed back to rotate the self-locking fixed position 5. The amount of gas in the spraying operation should not be too large, which may cause damage to the paint color structure and waste of paint. The spray valve knob can be adjusted to control the air flow size. 6. After the operation is finished or the material is added in the middle, firstly close the air intake source, pull up the pressure relief valve pull ring to remove the air pressure in the barrel, and open the lid when the pressure gauge indicates zeroing. 7. After using, pour a proper amount of clean water into the bucket to spray continuously to remove the remaining paint from the feed pipe and barrel to prevent the pipe blockage from drying. Open the lid and remove the connecting tube when storing