Donext Motorcycle Lift Scissor Jack, 1200 LB Capacity Wide Deck Hoist Stand Maintenance Bikes ATVs Garage Repair Center Stand Lift Jack, Black

I bought this to work with my Yamaha XT250 which does not have a center stand. I use it primarily for lubricating the chain, oil changes and any time I need the bike upright. The XT250 being essentially a dirt bike with lights, sits at a steep angle on its side stand making checking the oil level almost impossible.To use this lift, I put a 2x6 under the side stand to get it to stand up a bit more, and I use an impact driver with the supplied socket (nice touch!) to run the lift up to position on the bottom frame of the bike. As it lifts up, I just hold onto the seat or the handlebar as it's lifting up, and it's lifted, just like that!I see that they rate this lift at 1200 lbs, and it might actually do that, but I think it will lift just about any motorcycle on the market.It's fairly heavy and seems to be well made. My bike is light at just 290lbs, but this lift will do the job for just about any bike, at least in my view. I would buy it again!

This is very useful. I have an 800 lb motorcycle and this will lift it. It is easy to operate as well.

I will add a caveat on the stability of this stand in that it quite stable and built well enough to handle bikes probably up to about 500 pounds. After that perhaps one of those heavy duty hydraulic models that you roll under the bike and has a big jack handle. Still, this stand is more than capable and sturdy enough to handle any dirt bike and many of the lighter adventure bikes. Either stand I mentioned requires a bike to have a fairly flat bottom. I use a battery operated drill with the provided socket to raise and lower the stand for a 350 pound-plus Honda XR650L rather than hand crank a ratchet wrench. Both will work, but the drill is obviously much faster. I recommend lubricating the worm gear with a light grease for ease of operation. I use this lift in the shop and took it with me on a 10 day off road trip where I haul the bike out west and don't have any electrical hookup...hence the battery operated drill. I'm thoroughly pleased with this stand.

Was able to lift the rear wheel of my Yamaha V-Star 1300 off the ground in order to remove the wheel for a tire change. It works well. Only thing I would like better if there were some eyelets to hook straps; however, the bike was stable enough that I was not concerned that it would fall. I would not leave it unattended on this lift if there are small children around who could bump it and cause it to fall on them.

with this I can work on my 4x$ quad and my Harley Soft tail. Great purchase.

This has made wrenching on my bike a lot easier. I've got an '01 Sporty and this jack will lift it off the ground and it feels relatively stable. I'm sure there are better Jack's with bells and whistles but for the guy who gets just a little greasy now and then tweaking your own ride I'd call this a great buy

Center stand was a great purchase, very functional, I think it is a must have for any motorcycle owner.

Lift Bolt stripped rendering useless after few uses. purchased last year so likely cant replace. other than that, worked great for a short time.