Roof Top Rack Noise Reducer Wind Fairing with Cross Bars Mount Rooftop Carrier Air Deflector 43" Universal Aerodynamic Windshield Fairing Completed Kit

I was hesitant to order this product because of some negative comments but I tried my luck and made the order. The wind noise was terrible and annoying until I installed this one , the noise gone if not %100 I would say %90 which more than what I expected. The only thing that I didn’t like the plastic clips so I replaced them with screws to more durable and reliable. Otherwise highly recommended

The fairing is a perfect balance between thickness, flexible yet rigid, & durability. And the mounting hardware is designed well to fit anything. It's very aesthetically pleasing on my vehicle.My only complaint is that they could've thrown in a spare plastic pin since they probably cost like 5 cents.

As far as eliminating the wind noise it accomplished 100%. It was easy to install. Yes the spoiler is a little thin but it did the job.

The LT Sport Roof Top Rack Cross Bar Noise Reducer Wind Fairing is an absolute disaster and a nightmare to deal with. No matter how much you tighten it down, it refuses to stay in place and instead bounces around like a wild animal on top of your car. This constant movement is not only annoying but also damaging - the brackets holding the fairing are made of metal, and they have no regard for your car's paint job. Despite the supposed rubber pads meant to protect your vehicle, they offer no defense against the brute force of the metal brackets, leaving behind deep gouges in the paint. It's infuriating to invest in a product that not only fails to deliver on its promises but also ends up causing damage to your prized possession. Save yourself the headache and avoid the LT Sport Roof Top Rack Cross Bar Noise Reducer Wind Fairing at all costs.

The media could not be loaded. Fits great on my GTI or Q7. Only issue for GTi was middle bolts. Swapped them for shorter ones and good to go. Great quality too!

the included plastic pegs to mount the fairing was broken from the start, not that i would have trusted them to hold it on. the knobs were not manufactured properly and had to be drilled out to thread into the bolts. Otherwise, its a decent, dirt cheap, functional wind fairing, but be prepared to do some DIY work and add some extra hardware. the bottoms are metal, will scratch unprotected surfaces, but i knew this going into it.

The plastic screws wouldn't fit in the holes had to put my own screws. The plastic ones would bend or come loose.. had to run to homedepot as well you get what you pay for..

Was able to modify the mounts to run it on a votex oem vw rack. The fairing is solid and cut real nice, shipped with protection film. The angle brackets were all slightly different in bend which causes some variation but overall happy.