SGTKJSJS 60pcs Mini Heatsink Kit, Cooler Heat Sink for Cooling VRM Stepper Driver MOSFET VRam Regulators (8.8mmx8.8mmx5mm) Black

Ok shipping is not really their fault.... but it is perfect for what I need.. wife's account but I use it too.For inside of ebike motor controller to give it just that little bit more cooling in the summer.

Stuck these on VRMs when installing a G12 on a GPU. Stuck around 20 of these things on and let them cure for a few hours... they are 'upside down' in the case but not one has dropped off weeks after. Can't speak for the cooling as I don't have a 'before' measurement but the G12/Kraken + these has the card runnig >20 degrees cooler.

Only had 59 heat sinks...

Used these on a 1080ti with g12 bracket with water cooling. The included paste has been holding up well in the last few months as well. Great choice over copper if you have a fan to dissipate the heat.

These little heatsinks works really well. I decided to watercool my Zotac Mini 1080 GTX TI 11GB because stock cooling isn't really up-to-par. the Kraken g12 provides a fan that directly blows unto the VRM, but I figured, to prolong longevity of the card (since since its OC'ed) to add these things Most GPU failures tend to occur due to VRAM failure. VRAM needs two of these, while it lined up perfectly with the VRM. Use only a spec amount of the thermal silicon glue provided. In this case, LESS is BEST. See picture. Waited for a day to fully cure, and held extremely well. It's also easier to remove if I want to go back to stock. GPU Hot spots were at 60. GPU itself was 84s during full load 3DMark. Kraken g12 + AIO 280mm + these heatsink = idles at 26, and never goes past 50 during extreme VR Gaming OC @ 2060 mHz, 5600 memory