Emtel 20 AWG - 1 lb (318 feet) 99.9% Pure Copper Wire, Enameled Magnetic Wire for Motor, Transformer, Magnetic Coil, & Electroculture Gardening, Winding Magnet Wire - 220°C (428°F) Thermal Class

Very well made winding wire, used it to repair a 1940 oscillating fan. Worked fine and the price is right.

A nice compromise between weight, length, and cost. I bought this to wind a ferrous-cored long-wire antenna; works great.

This enamel wire on the right (air core humbucker), not buswire on the left (air core toroid). Toughest and most flexible enamel I've ever bent. Pliers barely leave a mark. Solder pot couldn't strip it. Wire is wire is wire, but the enamel and temper were just perfect. Can be scraped and sanded to expose copper, losing almost nothing, far less than tinning puts back. Exceeded all expectations.

Very happy with the quality. Arrived in a reasonable timeframe.

Was fine

I'm using it for craft projects and though it wasn't made for that, it really worked out better than I could have ever expected. It costs a lot less than the bare wires at present. Also, it has a protective layer that helps with maring up the wire. However, if you are kinda rough, you can't buff out any flaws you make, so if you're trying to get perfect jewelry, you'll have to show a little bit of care. That being said, it was very protective, but still possible to scratch when you are just heavy handed. Awesome product all around.

This is exactly what I needed for making some low voltage electronic coils.

Rewound my first motor. An ebike geared motor. I fried the motor over volting and over amping it. It was running fine for 5 years at 36 volts and 16 amps. I went to 52 volts and 30 amps and was fine then went to 40 amps and 2000 watts was too much. Totally burnt windings and hall sensor wire melted and gone.The motor was wound with 24g with 9 windings 8 wires. So actually the motor was 48 volt capable no problem. You can also do 10 wires with 7 windings and be fine. 9x8=72. 10x7=70.Have plenty for another winding if needed even with wasting some due to a winding procedural error.I eliminated the hall sensors as I use a generic non hall capable controller with no display. I use stand alone speedometer and volt and ammeter.

I am building home made speakers and needed to wind inductance coils for crossover. I used this wire and made very good coils

Elaboración de bobinas en un transformador

Diametre de la bobine correct.Émaillage de bonne qualité

Tolle Qualität für Antennenbau & Spulen wickeln DO3GDI,

Jag lindade om den för att göra en elektromagnet. Hade tråden från innervarvet också varit åtkomlig. Hade det varit enklare