Hogue HANDALL Ruger LCP II Beavertail Grip Sleeve Black 18120

Fits great and makes a huge difference on the LCPII. A little tough to get on. Used a hair dryer to heat up and put a little window cleaner on the inside to finagle it on.

The texture on the Ruger LCP II is very good. BUT, the grip is very small, and has "square shoulders". If you have a single stack sub compact to achieve as small a grip as possible, you may not need this. If you desire a bit more purchase on the handle, this may be a better option than grip tape. I barely have room for 2 fingers on the grip (stock). I wasn't sure whether the ergonomic fit would take up valuable real estate (the little bump molded to fit in between fingers). It does not. It still fits great. This gives the grip a little more width, and rounds out the shoulders, making it much more comfortable. I have 3 holsters for this weapon (pocket, inside waste band, and outside waste band). I've tried this grip in all 3, and have noticed no interference. This is with the extended grip (which on the LCP II is only a lip on the front of the magazine). Install - be prepared for a fight. Definately follow the instructions on the package. Those little strips that you cut out of the packaging are the difference between success and failure. While this can be frustrating, it is important that the fit is tight enough to ensure the grip will not move during use. I have Hogue grips on several pistols, and have never had an issue with them slipping during use.

This is everything you could hope it would be. It was easy to install, I just warmed it up with a hair dryer and it went on with no problems and very little effort. It was very inexpensive! It feels high quality, and absorbs just enough shock. It fits great! Such a great design, the gun now fills my hands perfectly and that extra finger notch for your middle finger makes the grip so much stronger. The biggest problem I had with the factory grip is at the back where the web of your hand fits, there is a sharp edge that painfully impacts the web of your hand when firing. This grip completely covers that sharp edge with soft comfortable grippy rubber!

This Hogue grip sleeve is great for making the grip on the Ruger LCP II 22 a little bigger and easier to hold. It fits fine and the one finger notch is helpful. I've combined it with the Tandom Kross Wingman 4 mag extension which allows all fingers to grip the gun and adds 4 more .22 rounds. This makes the LCP II much easier to hold. This was easier to install than advertised. I soaked it in boiling water and put the LCP II in the freezer. Then I spread a thin coat of synthetic gun grease on the handle and grip and slid it on. It hasn't slipped back off.

I was dreading the installation, but the directions were clear and there are good videos online. Boiled it, stretched it some, used the plastic shoehorn trick, and it just took a couple minutes. Without the grip installed, I always thought that the LCP felt like a Pez dispenser. Didn't fill my hand well, and I could easily imagine fumbling it in a defensive situation. This eliminates the Pez dispenser feeling, and makes for a MUCH better draw from my paddle holster. Feels much more secure. Should've gotten one of these a long time ago.