KBS Coatings 5400 Gold Standard Tank Sealer - 1 Quart

My china grom clone had a leaking tank near the float , as is common with the china bikes. I didnt prep the tank at all besides a wipe down and letting it dry from all the gas that was left. I did 3 coats on the inside from the bottom of the tank to almost all the way up the top, and 2 coats on the outside only doing the bottom half of the tank. Each layer both inside and out was done with 8-10 hours of drying in between. The grey looks kind of bad compared to the black tank, but other than that the tank has held up with no leaks going on four months now. My gas mileage has also obviously improved immensly as a result. The can is a little hard to open and the sealant is somewhat runny so its hard to apply precisely and not making a mess. Disposable brushes is recommended and it somewhat comes out of clothes after a few washes but i recommend wearing work clothes.

Our stock tank pool was looking pretty rusty. This did the job! 8 foot stock tank, and a quart was able to do the inside sides and bottom. Ran out of daylight, but it looks great. Would purchase again. Hopeful that it’ll hold up.

Follow the instructions to the letter and it works great. Try shortcuts and it a mess that is hard to clean up

Sealed my 1964 comet gas tank. Quick and easy.

I have used this product before it worked great on motorcycle and atv tanks and lawn equipment too now I am going to coat my tractor tank.

Great paint

I had aluminum plates welded on the ends of an aluminum boat tank as bold down mounts to use it under the deck of a flat bed trailer. Unfortunately the welder was not a good as they claimed and left several holes that I could not get to with glue. This completely sealed the holes. As it was running out of the holes, it slowly sealed them and now the tank is air tight.

Easy to work with