Gledewen Exterior Chrome Door Handle Front Left Driver Side with Keyhole | Smart Entry Keyless | for 2010-2013 Nissan Rogue | Replaces# 80640-CZ31B, 80645-CA000

I can’t comment as to how the whole handle works on a Rogue, but the button for lock/unlock with the Intelligent Key is the same used in many similar Nissan and Infiniti models with similar looking handles. After much hassle and frustration, I was able to take the handle apart and replace the original button with the one I removed from this handle. Spliced the wires in and it works perfectly, plus the new button has a more solid click when pressed.Great option for those who are mechanically inclined with a similar issues as mine (driver’s door button was not always working unless pressed in a certain way)

Replacement

The quality of the handle is as substantial as what came on the car. Unfortunately the range on the key fob detection is poor compared to the original. The original would detect the key in my pocket. This one I have to move my hip very close to the door to get the the button to unlock the door. It was cheap, though and does the job. This is a minor annoyance, but just something I felt should be pointed out on this product. The connector does require you to take apart the inner door, which is a pain because the inner panel screws into the window lift mechanism. This is Nissan's fault, though. This would happen with any handle product so no big deal there. If you get the one without the smart button, it's very easy to install.

Works great. Took me an hour or two to install. Took my time to ensure I followed the youtube directions right. Could do it in 40 min if I ever needed to do it again.Not sure what the complaints are about it not fitting. It fits just fine. Getting it to click in behind the latch can be tricky but it absolutely fits. (My car is a 2010 Nissan Rogue SL).Range isn't that great for the button unlock. But only a few inches shorter range than the original handle. Not a big deal. Considering the dealer price is like $400 for a handle, totally worth the savings for the slightly shorter range.Looks like the original. The wire is longer on this than the original handle. Just tape it to another wire and you should be fine.

The handle is for my ‘12 Nissan Rogue... the handle is just a bit to big and it’s hard to open the door. Installing it is a pain, and the fob has to be right next to the door to use the keyless unlock... Not good considering the work and time it takes to replace it... Installation is not the fault of the handle, but not worth going through for a replacement

Justo como se describe, 100% sirvio nissan rogue 2013

Just installed on my 2013 Rogue and while it will open the door, it does not perform other key functions. After pulled, the handle sticks out and does not retract/pop back into the door. Also the key fob has to be within inches of the handle in order to be detected and allow the car to be unlocked/locked by pushing the button on the handle. I wasted the 1-2 hours installing this defective handle and will now buy the OEM part.

The media could not be loaded.  Easy to replace using a 10mm socket, a T-30, and a small pick. Watch a video on YouTube. The keyless button works, you just have to break it in or push it correctly.

Fit perfect

Installed this in less than half an hour, tested all functions and checked for dtcs after none found highly recommend

Fitting is good, but the sensor doesn’t work 👎🏻