Performance Tool W134DB 3 Jaw Gear Puller Set, 4-Piece Set (Sizes: 3, 4, 6 and 8-Inch), with Reversible Design for Vehicle Maintenance and Repair, Drop-Forged Steel, Chrome Plating

I used this to pull my steering wheel off my 2001 Z06 corvette. Worked like a charm and made the job super easy!

Good value for the money. Perfect for light use, like for the advanced do it yourselfer.

This seems typical of less expensive pullers and not bad at all. The gear I was removing popped off relatively easily so can’t comment on strength of the hooked end but overall it is fine and in line with price paid.

Great value, works just fine and easy assembly

I wanted to replace the steering wheel on a Club Car Precedent golf cart. No amount of hammering, beating, etc. was pulling that steering wheel loose. I watched the videos, I read the instructions, I used copious amounts of penetrating lubricants. Nothing. 15 minutes with this puller, including setup, and my steering wheel was off. I had a single use for this, and it worked EXACTLY as it should. Fast and (relatively) easy. I shouldn’t have tried so hard before ordering…

Comes apart too easily

The Jaw pulley puller worked perfect! Built well and why drive to Kragen to rent one when the price is right to own it! I used it tp pull off air conditioner pulley, It pulled it right off like butter! Save time and money from from running around to find a place to rent it...Its right here!

DO NOT BUY! Product came in broken packaging, could’ve either been used or because the plastic sheathing is the most brittle plastic I’ve ever had the displeasure of touching. I’d like to think it’s used, because on my first attempt to use it (pulling a pulley off of a 5/8” shaft) it began skipping the teeth on the center rod under very little load because of the gigantic tolerance faults between the inner diameter threading and the rod. Would not survive any load, look elsewhere.

all good

Goood

funciono muy bien para desatascar bielas de bicicleta que estaban barridas y no podia usar un extractor normal

Exactly as described, totally fit for purpose.

I tried to change the rear rotors of my C300. Succeeded in the left rotor but failed to remove the right rotor. Hitting the rotor with mallet for 15 minutes was totally a waste of energy. Getting and Mounting this tool on the 12 inches diameter rotor after researched from internet. I turned only 1 and half rounds of the puller, the rotor popped off with a cracking sound. The removal was done within 15 seconds. The puller is a very strong and does an excellent job for me. This is my first time to do the 100% brake job on my own.