Samlight License Plate Bracket 8 3/4 Inch Flip-Up Winch Roller Fairlead Mount Holder Black Stainless Steel

Works great, installed on badland winch.

The media could not be loaded. If you have to run a front plate this is the easiest way to mount to a winch fairlead. Perfect fit on the fairlead that came with my 9500# Badland winch. If your fairlead has snap rings holding in the rollers you will need to replace them with bolts. To allow your plate to sit flush to the bracket you can flip the screws that hold the roller clips so that the Phillips head is on the plate side of the bracket.

It's easy enough to install and, for the most part, serves its purpose. My license plate fit w/o issue. However, the issue lies with the brackets on the back...they were too small to fit around the rollers on my fairlead and pop right off with the slightest bump. I had to secure the plate holder at the bottom with some wire I had laying around in order to keep it from popping up. It would be nice to have something that is adjustable and more secure to go around the fairlead rollers...maybe velcro straps or an adjustable clamp of some sort.

Fits great and looks nice

Mine came missing one of the threaded inserts for the license plate bolt. Kinda a bummer but i still had 3 more to hold the licnese plate on with. The holes for the roller fair lead were about 1/4" off mine. It fits but causes it to bow a little bit. It does work though and was a fraction of the cost of other brands so im ok with it. In reality it just needs to hold a plate to keep the man off my back and swivel up fir when its time to winch which it does.

I was shipped an item that was obviously returned. It is missing nuts and screws. It also came with some random hooks that do not belong with this item at all.

Lots of people complaining about the quality of hardware included. I was more concerned about if it would mount on my 80 series ARB winch bumper. It actually ended up working great using the lower snap rings on the roller bars. I didn’t se any instructions for installing so here are my suggestions. You need the following tools: snap ring pliers, 8mm socket, 4mm hex, Phillips screw driver, and 5/16 drill bit. I removed lower snap rings and installed mounting bracket. Then reinstalled snap rings. Next I reversed the hardware on the roller bar clamps as other reviews had suggested. This allowed the plate to mount more flush. I made sure the clamps were centered before tightening. Note on the hardware: It was stainless steal and I found it adequate. Prior to installing the license plate I enlarged the holes on my plate to 5/16”. This allowed perfect fit of the 4 hex head bolts without bending/warping the plate. Some folks talked about adding a horizontal slot to get their plates to fit. Trust me that drilling out the hole size is the quick and easy way to go. This item has room for improvement but I give it 5 stars for overall value.

Fits great! Seems to stay in place at highway speeds. The only downside is the license plate doesn’t sit flat due to the hardware orientation.

Facil de instalar, muy practico para la colocacion del portaplaca y resistente.