Pole Mount Kit for 30W to 60W Solar Panels,Heavy Duty Adjustable Aluminum Mounting Bracket Kit with Hardware for Outdoor,Solar Panel,Antenna,Camera Mount,45-Degree Tilt Mount Fits 2-Inch Diameter Pole

It's a lot beefier than it looks in the product pictures. I had reservations about the method used to set and hold the desired angle. But once I had it in hand, those reservations went away. It has no problem holding the 50W panel I used. I would have liked some spring washers for the two bolts that hold the angle, but that's more for a warm fuzzy than an actual product deficiency. I had to use the provided clamps to hold the Callsun 50 Watt Solar Panel. The top clamp is hard to keep straight when you are also holding the solar panel. An additional slot/tongue on the top clamp would alleviate this. Or have another person help you. Or, mount the bar to the panel before attaching it to the bracket. I would by this again. And, its pieces will fit in a suitcase!

Bracket is a quality product. It is a little light on the hardware as in flat washers & lock washers. They engineering, material and tooling are outstanding. The edges on the bracelet as others have mentioned are a little sharp. I ran a file over the edges before pealing the protective cover off. I mounted an Amazon supplied 50 watt solar panel on a 9’ long 2” post in minutes. The bracket and the panel together have put an end to my driveway gate opener battery charging issues. Thanks to all the fine craftsmen that helped along the way.

Update: The seller has raised the price on this unit by nearly $10 dollars, which greatly reduces its overall value. The quality is still high, as far as I know. But at the new price point, there's plenty of competition out there, and some less expensive units may be more attractive now. Original review: Very impressed. A good value, simple sturdy design, high quality materials and workmanship. This mount for small-ish panels is much, much stronger and more robust than I expected. Very easy to assemble and install. Mine is currently supporting a 25W mono-crystalline panel, and doing a great job of it. I also checked a 20W mono panel, and that popped right on just as easily. I think if you go much bigger the panel may end up oriented horizontally so the narrower orientation of the panel will still be spanned by the main arm of this mount - but there's nothing wrong with that. If I have one complaint, it's that the pipe clamps, while of high-quality, stainless steel - are sized for a metric driver or flat screw driver. That's a pretty nit-picky complaint - metric hex drivers are just not a part of my regular tool kit, and cinching a pipe-clamp with a screwdriver is a frustrating experience. Anyway you can use any hose/pipe clamps you want, though stainless would certainly be smart.

It’s not painted orange on the corners, I did that as a safety precaution bc the edges are very sharp. when mowing it would be easy to slice your head if you weren’t paying attention. I think the solar panel mount works well, it’s adjustable and sturdy. I felt it was easy to install but I’m pretty mechanical in general.

Installed on a post on dock to be able to recharge battery. Seems to be well made and should do whats it is designed for using with a 50 watt panel. I used as shown in pictures( Renogy 50 Watt 12 Volt Monocrystalline Solar Starter Kit ) instructions were scant for pole mount kit and need improvement but enough to get the job done. Some drilling on the back mounting plate was required since the holes did not quite match up. Solar Panel Pole Mount Kit Single Arm Pole-wall Mounting Brackets Support Solar Panels from 5W to 50W

I had an Internet satellite dish removed from our property and they left the steel post and small dish that received the signal. I removed the dish and mounted a 20 Volt solar dish on this device which places it up in the air getting early morning sun. It came with mounting bolts and straps to go around a post of varied diameters and it all went together simply. I recommend it for solar panels that are smaller in size. I would not put one of more than two square feet on this particular mounting system.

I am confused by this review section as many seem to be written regarding a pole mount. My review here is exclusively for the "Adjustable Solar Panel Mount Mounting Rack Bracket Set Rack Folding Tilt Legs, Boat, RV, Roof Off Grid (40.5 - inch Length)." The product above should work fine for mounting smaller to medium-size solar panels. For my 300-watt class panels that require a little over 39 inches between mounting holes, the main bracket arms were a little too short and could not be used, despite the claims in the marketing text. Even if the bracket arms managed to be 40.5 inches long, the closest mounting holes to the ends were well inside of that distance on both ends so there was no way to bolt them up without drilling new holes that would have left very little material left for structural integrity. The description should be revised to indicate only the distance easily covered by the bracket arms between mounting holes with no suggestion that they might cover more.

Sturdy and worth the trouble. Better than making your own. Leave the blue plastic on to assemble on pole. Comes with gloves to avoid cuts. Buy lock bolts and nuts and l hardware to attach solar panel. Attached drawings to assist anyone else. Also, I'm just hooking this up as an alternate temp system to see if it will boost my existing panel that gets shading, therefore using a T farm bar. pic of it above. Will include additional pics when complete. Waiting on stainless washers and nuts.

Good price

Aluminum struts are strong and perforated for adjustment bolts for almost any position. Once assembles, its easy to adjust the angle. Simple, straight forward, useful, well made and serviceable.

God solid item, well finished with no sharp edges.

Perfect for the solar panel.

perfect for attaching to solar panels and a frame