3MCA-420 DI-NOC Graphite Carbon Fiber 3in x 5in (Sample Size) Flex Vinyl Wrap Film

Look great. Must be carefully measured and cut to fit before application. When applying, be certain to go along it's length and "push" out any wrinkles to ensure a smooth final fit.It has stayed on and looked good. I've used it on several applications and have been satisfied.Further, a bit of heat, as with a hair dryer, will help ensure a flat fit on those difficult areas where the wrap tends not to conform to the surface curves. Just don't get too hot, as this is vinyl and will be damaged. Then you start over again. A hair dryer worked fine for me and got me past those rough spots, especially after I had applied the wrap and then noted a few areas where a "wrinkle" or air pocket appeared. A bit of heat and you can "push" that pocket out to the side and get rid of it...not every time, but often enough that I recommend using that technique if such a spot pops up after you have applied the wrap. It happens...so just take your time and push down on every square inch as you wrap your object and you won't need this handy fix.

I used this for my car dashboard pieces and it applied easily and looks great. This DINOC is heavier than the scotchprint vinyl carbon fiber wrap. Be sure to do good surface prep, any rough areas will show up. Cuts easily and has enough flex for curved areas using a hair dryer on low heat. The graphite color shows the carbon fiber design better than the black. Don't know yet how it holds up over time, but I'm optimistic it'll do well.

Is good