🔌 Power Up Your Adventure!
The Insta360 One X Charger is a high-efficiency 3-in-1 charging station designed specifically for the Insta360 One X action camera. It features three charging ports, allowing you to charge up to three batteries simultaneously in just 60 minutes. The digital LED display provides real-time updates on battery status and voltage, while built-in safety features protect against overcharging and short circuits. Its compact and lightweight design makes it an ideal travel companion for outdoor enthusiasts.
T**M
It charges 3 batteries, and everything else about it isn't good.
The media could not be loaded. First off I must divulge that I was approached with a free unit in exchange for a review.Before being approached, I had seen several of these chargers on Amazon, under several different names. I avoided them as they appeared to be the run of the mill, cheap, no-design, straight from a Chinese factory, item. I then passed them all by and purchased the Insta360 branded dual charger.I received my charger in a fairly nondescript brown cardboard box. Inside was the charger and power supply. My initial impression matched that of my snap judgement when scrolling by them on Amazon. It is constructed of two pieces of circuit board material, one printed and the other holding the very retro LED counter style display. The two circuit boards are held together using 4 screws and plastic standoffs. There are a few pieces of dense foam used to fill in parts of the void between the board and creating the bays for the batteries to sit in. The foam leaves the majority of the circuitry exposed, visible, and if your fingers are as small as my 4 years old, able to be touched. The assembly of boards sits (likely glued) into a plastic tray proudly embossed with "Made In China."Using the charger is fairly simple. Three batteries sit upward, held in place in a battery bays about 1/4" deep. The bays are mostly that of the previously dense foam with a top layer provided by openings cut into the upper circuit board. These cutouts have very sharp edges, and the tolerance between edge and battery are very tight. I found that my charger's charging leads needed a bit of nudging to line up properly. The LED readout was hard to read and flashes the various bits of information about each batteries charging status in sequence. I would have much rather preferred a simple charging bar as the flashing information cannot be read at a glance.After my second use, the barrel plug on the power supply started smoking, and when unplugged showed signs of melting. I will be immediately disposing of the charger and power supply.All in all, the charger charges batteries. That's all it does, that's all it was made to do. It is not kind on the eyes, it feels like it could shock you at any moment. It gives you information about the batteries that you probably don't care about. And it's really cheap, but might catch fire.
O**T
Works Buuuttttt!!!!
Well lets go with the Good.1. Its small2. It works (sort of)Now for the rest. I have 2 batteries and drained them both. put the batteries in the 1st and 3rd slot and left on the charger for over 4 hrs. Now, All the flashing numbers that just flashing randomly even if the batteries arent in ...shows the Channel or slot number...some amps and whatever else. Basically...there is no real way to tell if its charging because this information does not change. looks more like an error than a validation that its actually working.With that being said, after sitting all that time on the charger, only 1 battery was charged. I put the other battery back in the 1st slot for a few hours and it charged up.So, im not sure if it charges all the batteries at the same time, i dont know if the 3rd slot is defective and i dont know if you have to have the batteries in order, without leaving slot 2 open.Its a good thing i only have 2 batteries, so can still have 1 charged.
J**N
That’s the Insta360 One X external battery charger you are looking for!
This charger is exactly what I was looking for. It allows fully charging of my 3 Insta360 One X batts at the same time, and I’m ready to roll again in no time. Convenient external power supply is also included, or you may provide USB connection for charging as well. Just make sure that when the channel gets to 0.0A means the battery on that bank is fully charged. Very happy and pleased!
M**K
Great accessory!
I needed a multi charger for my ONE X batteries and this one peaked my interest and it works great! It gives you the voltage of each channel as it’s charging as well as the AMPs, if your needing a charger ide recommend you give this one a try and see if it works for you!
W**A
Works better then The Insta 360 Brand!
At first glance i was worried. it looks like it is unfinished, but once i plugged it in my worries slipped away. popped in 3 dead batteries, charged all 3 in under an hour, and from my Anker battery pack!! My biggest issue with the insta brand is it must be plugged into a wall in order to work. this doesn't help when you are on a location shooting. I am very pleased with this product and would recommend it to anyone with an Insta 360 one X!
L**T
Great Charger!!
Great charger and works great for home use. Although not USB powered. It can charge all 3 of my batteries at the same time versus the propriety 2 battery hub from insta 360.
R**A
A really good charge for the low price
I missed the instructions on the back of the box at first on how to tell if it was done charging or not . But once I did it was very easy to read and understand when batteries were fully charged. Was very shocked on how fast it was done charging. Very happy with this charger.
B**D
Great for charging my One X
I am a Google Trusted Street View photographer and use a One X for some fun projects on the side. This charger keeps multiple batteries ready to go at all times.
Trustpilot
2 months ago
1 week ago
