36Pcs Stamp Punch Engraving Hobby Jewelry Metal Work Tools

I was quite surprised at the small size of these stamps, probably because they just did not look small in the photos. They are about 2-3/8 inches long and about 1/8 inch in diameter (about 4mm). But I love that the designs are small as I am going to use them on smaller pieces of metal in jewelry.If I could get a larger set just like this one, I would.The stamps arrived loose in a small zip bag, the inside of which was pretty much black. A few were a bit rusty, as you can see in the photo above, but I sprayed everything with WD40 and wiped them down, which took off the excess black residue. Then I coated each with sewing machine oil and wiped them down again before putting them in a stamp holder I made from scrap lumber with 3/16" holes drilled in it.These stamps will work fine, but probably will not last long if used on harder metals. Bonus: Along with the flower there are two sizes of leaves, and each leaf comes in a right and a left facing punch.

Made out of a non hardenable mild steel alloy. It easy deformed when using on annealed brass.