moinkerin 5 Pieces 2 Pin Waterproof Electrical Connector Plug 12v Waterproof Connector Automotive Wire for Boats, Motorcycles, Scooters, Trucks, Quad Bikes, Bicycles and Tricycles

Quality seems good, not tested them outside yet though.

If you need a low voltage connection that's waterproof, this product is absolutely ideal. Saved me hours. All I had to do was twist the wires together, solder them, heat up the heat shrink sleeve and the job was done, in minutes.I don't know about the quality of the components, they look OK to me and only time will tell. But in terms of usability, they are perfect. Absolutely no reservations in recommending them.

Did the job not bad for the price little tricky to use, quality is good but we'll see how they hold up over the winter months.

Just what I needed for my camper van

Quick release tight fit good

Used to tap into the 20A power outlet fuse on my KIA ProCeed to run a power cable to install a rear multi power outlet unit. Easy to connect, has all the bits you need. Soldering recommended for the best connection.

The connector come with short leads attached so no need for special crimping pliers. However the appliance leads need to be attached and insulated. I soldered mine and covered with shrinksleeve.I used them to make a break in garden lights, they are satisfactory and provide a sealed connection that can be separated without too much effort.IThe supplier delivered promptly within the timeframe given.

So far I've used these connectors for my LED light bar, Pair of horns, fuel filter water alarm, dash wiring etc. I just solder in the connectors and heat shrink the joint and all the hassle of crimping and making up the connector is gone.