Tamp Tool for The PX 2 and 3 and Coffee Tea Tamper

I use bud kups 3.0 for my pax 2. They don’t really sell a tamping tool for the bud kups that fit the entire length of the bud kup chamber. The tamp tools that are available out there are usually round and small. This makes it so when you are pressing the flower in the chamber,, you have to press several times per layer, which can lead to uneven pressing.In my search, I found this tool and I purchased it just to see if it would fit inside the bud kup chamber. Since its made for the actual Pax2 oven chamber, I was afraid that it would be a tad bigger than the bud kup chamber. Lo and behold this tamp tool is almost the perfect fit for the bud kup chamber. I had to shave down the lip on the tamp (most likely created from the 3D printing) using an exacto knife and some sandpaper.After doing that, it was a perfect fit and it works perfectly in pressing the flower evenly in one shot. Very much so like a tamping tool for an espresso shot.Highly recommend both the Bud Kups and this tool.!!!

As a long time PAX user this tamp tool is without a doubt is the best accessory I have for my PAX2/3. It perfectly fits into the Bud Cup insert (sold separate)and is a simple to use and you will love how easy is packs/tmps your flower into the pax oven chamber.Buy it and love it.

It’s a 3-D printed tool. At first I was concerned, but it turned out to be just what I needed! It fits my PAX perfectly and I keep it tucked in a bag with my other tools, so the lack of a key ring is not a problem at all.A very nice, inexpensive little replacement.

It gets the job done pretty well, but about half an inch of the handle broke off after 8 days of daily use. The material it's made of could be better.

I bought a different flower packing tool, metal with a tiny handle, and it was SO useless. I fantasized about my ideal packing tool, and lo and behold, here it is, on Amazon. It's a fabulous item! You must have the funnel, too, of course. This tool is also useful, on its narrow end, for digging the dried-up, used-up flower out of your Pax after your vape session. It does tend to get pretty sticky with resin, but a little isopropyl alcohol takes care of that nicely. This tool makes packing my Pax so much faster and less messy, it's amazing.

Very smart tool. A 3D printed tamper tool. I actually like it much better than the original pax tamper because I have arthritis in my hands and the original is too small for arthritic hands but this holds well and is longer and thicker but not too think. Love it.

I would have given 5 stars but because it’s plastic, if you are filling your next bowl right away, the oven is hot and the product sticks to the tamper. Fits pax 2 & 3 perfectly. It does what it’s intended to do. Love it.

Fits perfectly with the pax mini. Easy to use and clean! Definitely recommend