Robocraze 76MHz-108MHz Wireless Stereo FM Radio Kit Audio Receiver PCB FM Module Kits Learning Electronics for DIY 1.8-3.6VDC

First, those planning for use of li ion battery, this runs from 1.7 to 3.8 volts safely. More than that will lose the reception. You need a diode of 0.5v or higher forward bias in series with lithium batteries.Second, the ic soldering is quite tough. Not for novice. You need a holding arrangement and expertise in quick smooth soldering. Rest is very easy.Third, it's sound quality is really very nice and of course it is stereo. That's a big plus.Fourth, while others suggest missing parts, I received all parts ok with proper value. No complaint here except for the battery holder- the last one is terrible.The seller is very responsive, polite and helpful. So, try it. It's nice.

Those who are living in remote area, this module is not for them. I was very anxious to do it in my own hand after a long long time .. but everything went in vain… May be a good module for others.. but not for me …01.09.2024After long time research, I came into a decision that it has only a Yellow LED and Oscillation sound … Feeling Totally hopelessness…

Working very well.must buy.

This is not for beginners and cry babies those who don't have general electronics knowledge and electronic parts identification experience, you need real good expertise of quick soldering and smd arrangements tools to assemble this kit, slow soldering with longer exposure to heat will destroy the components and you'll cry in review section that your kit isn't working after soldering, it's a value for money product 101%, best in the market fm reciever kit far better than manual tuning assembled boards available in the local market and elsewhere. Totally worth it!

They are cheater fraud Worst product I assemble the pcb only noise is not a single radio channel catch on it totally waste of money not buy it

Following serious drawbacks:1: No ferrite rod with coil and thus at least 100 ft long Ariel wire installed at roof top and a earthing is required to get signals2: weak Transistor and diodes3: no variable capacitor for tuning stations and is tuning depends on press buttns not tuned3: it cannot be used in absence of a simple cabinet.

Nice

All the parts were provided and a bread board. we have to solder all the parts on the bread board using a solder kit . but the soldering of the IC is compicated . Only buy if you are good at soldering otherwise you will have to give to a local shop to the soldering.