WINDFRD 1.5" Ball Short Arm Fish Finder Mount, Marine Electronic Mount, Universal Mounting Plate with 1.5 inches / 38mm / C Size Ball Adapters, Compatible with Garmin, Lowrance, Humminbird and More

This mount is easily installed. I installed on my Bass Tracker console in the cut out for the cup holder. I used a round electrical box cover (with gasket) and it fit perfectly over the hole. It is a little cumbersome to get the nut on the bolt under the console, but using duct tape to tape it on to your wrench helps muchly. Use stainless steel with nylon bushings saves trying to hold washers and nuts at the same time. Nice sturdy mount. RAM is still top of the line, but this is a near match and works great. Mounter my Garmin ecomap 93 fish finder on it and it is plenty sturdy.

Made in solid heavy duty aluminum pieces with a coating that grabs tight with almost no pressure.Very solid and easy to install.

WINDFRD 2.25" Ball Fish Finder Mount, Super Load-Bearing Marine Electronic Mount, Universal Mounting Plate with 2.25 inches/D Size Ball Adapters.This WINDFRD 2.25” Ball Fish Finder Mount is a SOLID, ALL METAL (ALUMINUM), WELL-MADE Unit with the Balls made of a high-strength corrosion-resistant composite material that doesn’t weather or rust.If you are looking for HIGH quality and well-designed, this unit fulfills the requirements.It is NOT a cheap knock-off by any means.It IS Super Load-bearing, and it holds my Garmin Ultra 126sv Fish Finder and mount of 9lbs, rock solid! It has a 22lb in-motion weight capacity and a 110lb standing support weight capacity that more than covers most larger Fish Finders.It has unlimited positioning/angling and a solid mounting base. It also comes with a long arm tightening wrench that has spring detent pull-positioning to reposition the arm for super tightening to achieve maximum clamp pressure.Super cool tool!I highly recommend this unit and it is one of the best Ball Type holders I have crossed paths with.One note: On this 11” wide mount, you may have to shift some units just left or right from ‘center’ about .5” to match the mounting holes available.Other than that, I did not encounter any negatives on installation and the clamp holding strength is ROCK-SOLID!SO, I am giving this WINDFRD Fish Finder 2.25" Ball-Mount 5-STARS.

Easy to install, very sturdy, works as advertised.

seems to be well made. all metal -no plastic. Holds my 9" unit in place. will buy another later for the bow of the boat.

Exactly what I wanter, even better quality than I expected. Definitely would purchase again.

It's working perfectly for lowrance elite fish finder.

Had a ram mount that had a 1” dia ball. Went up to this size and had no shake holding my Lowrance fish finder. Highly recommend