Universal Turbo Intercooler Aluminum Pipe Piping and Silicone Hose Kit w/Stainless Steel T-Clamps(3inch,Black&Red)

Doesn't weld too bad after you clean it up with a scotch pad! Used it for my Supra.

I wasn't expecting much from this kit considering the price. SO...The good-The pipes welded nicely, you just need to pay attention to the fact that bends make the inside material thicker and the outside material thinner.- it comes with a decent amount of couplers and they seem adequate at least for my build (only running 9psi)- it has a decent amount of material you are getting for the priceThe bad- when it shipped one of the pipes got deformed from how it was packaged- these pipes are not clean. The grease they use during the bending process is not completely cleaned out and it looked like there were a couple pieces of debris in some of them.- finally the most frustrating thing was the t- clamps they provide. They don't seal because they are too thin and deform. The bolts are almost maxed out when you do get them to hold pressure and they don't hold for long because they loosen up from the frame deformation. And the edges are sharp so if you are in a tight space expect some marks from rubbing against them.ConclusionOverall a decent kit, I would recommend it but I would highly caution people to get better t- clamps.

Affordable 3” intercooler piping, but came with damaged/dented ends on the pipes. Some didn’t even have a bead rolled on it, so if you get this make sure you have a bead roller. Pipes were dirty with aluminum flakes on the inside. Overall usable.

Hey the kit is good for the money. When you have to trim some oh the pipes to fit you will need to get a bead roller or do the wire crimper trick so the couplers don't blow off under boost..... You know almost every turbo charged air system has a pressure relief valve. Well there is'n a pipe with a flange on it. That means you will have too buy a 3" pipe with a flange in it. Then hope you don't have to buy an adapter for your valve or get a new blow off valve..$$$. Just how it is.

The aluminum pipes look good and are nice and thick to enough to be durable. The silicone joints are decent, only complaint would be the clamps are basic with sharp edges. That being said they do work and this is a far cheaper option vs getting custom piping done.