Neoprene Rubber Strips Self Adhesive Solid Rubber Sheets, Rolls & Strips for DIY Gaskets Crafts Pads Seals Warehouse Flooring Rubber Strip with Adhesive Backing (1” Wide x 1/16" Thick x 10' Long)

Adhesive is super sticky, and the strip is easy to work with. It lays down quick and easy and follows slight curves without buckling. I used it to replace worn and rotted factory rubber at the bottom of my Expedition windshield and with how well it worked there I’m going to use it at the top of my Charger windshield for an added seal and to give it a finished look. The double sided tape will not hurt the paint if it ever has to be removed for some reason. A little bit of WD-40 or goo gone and what’s left over from the double sided tape will be gone.

Very nice product. Sturdy and the adhesive is nice and adheres well. Use it in the base of a lanai door that was neede to be replaced

Great product

cut some 2-3- squares...adhesive can come off rubber when removing protection....careful...otherwise, sticking to vertical aluminum pretty good after couple days

So far this product is working like a charm….

I wanted this to put between a newly painted steel trailer frame and a fiberglass camper shell that sits on that frame. It went on easily. Cuts to length with good scissors. Seems to be the right compromise of softness for cushioning and firmness for durability. The adhesive is good. I had to remove one small piece due to an error in my part. It was hard to remove but doable, and no damage to the paint underneath. Very pleased overall.

It appears very heavy duty, only time will tell, it will be used as a truck canopy spacer/sealer.

Strong rubber backed by a pretty gelatinous adhesive, might work depending on your application. I'm using it as a liner on a power rack, which has a lot of focused pressure from the barbells, which tends to cause it to slide. If your application is more disperse, it's probably fine.