19 Inch 1U Cable Management Horizontal Cable Rack Mount Manager with mounting Screws for Service Rack Cabinet 24 Slot Finger Duct with Cover

Works great with my CAT6a slimrun cables from monoprice. The holes from the back work great for passing cables in from behind the rack also, nice surprise. The model I purchased has the narrower depth "finger" so be careful if you have long plugs as they will be hard to bend into the fingers. The monoprice slimrun cables just barely plug into my switch then bend down into the fingers, tight fit. However, it looks cleaner since it doesn't stick out as far. This product is also made of a nice quality metal and not plastic like the ones I'm used to at work. Great value! Just be a bit careful you don't pitch your fingers when you take the cover on and off, it can bite.The included cable management Velcro strips was a nice touch.

The 1U cable management is metal and solidly built. Easy installation and included the bracket and screws to install. Traditional front panel access is easy to use and holds with strong tension when in place.Performs as expected, would buy again...did buy again.

I like the cable management tray a lot. I must not have paid attention, tho, because the cover and the fingers are all metal, not plastic! Eek. It's just a wee bit concerning for when snapping the front cover back on... *watch your fingers*!! ouch. I've been cut twice, now. Granted, it did say "cold rolled steel" in the description. Regardless, I'm not gonna complain too much. It's a good product, works well. I like it!

Nice product.

The mount works as expected. My complains would that:(1) If set up directly above or below a switch, the cabling is very tight(2) I have several times run into an issue when I didn't seat the face plate well on the connections and it fell off.There are benefits that some may find with the small form factor, particularly if you were placing it in a cabinet with limited space, but if you are constantly changing wires or have a large number, you may want to go with something that is better sized and has a better connection for the faceplate

This review for: Lancher 19 Inch 1U Cable Management Horizontal Cable Rack Mount Manager with mounting Screws for Service Rack Cabinet 24 Slot Finger Duct with CoverGood for smaller racks with a less cabling when you don't want 2.5"+ cable management extension sticking out the front (which may make some rack doors difficult to close). This did the job, fit well, and was a much better alternative than similar deeper solutions.If you have a large bundle-o-cables, trying to thread them through a shorter depth can be a bit tight (as others have mentioned). My solution was simply to bend up every other finger to allow a bit more space. Still allows firm closure on the cover and keeps everything tidy and nice looking.

Cover is easy to get on and looks great installed in my data cabinet!

Only thing I would have done different is use slim cat6 to make it a drop nicer,. But the regular cat6 cables worked fine.