Leather Burnishing Tool,Yangoutool Slicker Pointed Head Leather Tool Set and Leather Burnisher for Dremel Rotary Tools

The fatter one is decent, and I can use it as a starting point, the long skinny one that I bought the pack for was and is worthless. It wobbles so bad I can't get it next to the leather. I was hoping if I sanded it down some it would balance out but the shaft is set wrong

The concept is great but the wooden part is not on the shaft correctly on either but so they vibrate to the point of being unusable.

Fits my Dremel perfectly. The different curves of the tool head allow me to quickly burnish long straight sides, follow curves, and get into tight areas without changing bits. I've only been using it for about a week, but this bit hasn't left my Dremel yet, and is getting a daily workout. I thought it was a bit pricey, but if it lasts it will be worth it.

This is a solid smaller hammer. I plan to us it with my chisels when woodworking. Other hammers are too big. The head of the hammer fits closer or enemy in my hand for greater accuracy. I like it so much I gave it a good sanding and applied a wax.

Very disappointed. The wood is finished beautifully. The metal shaft appear to be finished on a bench grinder. They are not round so the whole tool doesn't spin smoothly. They are also a size that doesn't fit into any collet. Too small to actually tighten in the normal dremel tool collet but too big to fit into the next size down.

Dremel tools spin at high speed. Both of these tools were unbalanced and vibrated terribly even at slow speed. The metal shaft is made of a very porous metal which bends as soon as it warms up from the high speed. Dremel tools are balanced and use stainless steel shafts. I'm amazed you haven't been sued by Dremel for using their name. THIS TOOL SHOULD NOT BE SOLD IN THE USA!

Purchused 1 figuring this would be a simple design to burnish faster. large one bent at the shaft first go. figure maybe defective shank. order a replacement and it did exact same bend at the shank. This will work great if you just want to hand burnish.......NEXT.

These are crap! I placed the larger one in my Dremel tool, set on 4, and turned it on. In less than a second the shaft bent to a 60 degree angle. Total and complete JUNK. Do not buy!