WOL 3D Spool Holder for All Type of Filament

Quality is not as good as earlier lots, packing also very poor, two spools were broken, winding is much better now.

good quality filament... atleast the best in its price range....the prints come out of good quality.... however, they are not perfect...after you buy the filament, it will print perfectly for a week or so, but as it begins to retain moisture...you will see some stringing happening in the prints....well, that's because i keep it mounted on the printer at all times....if you have a dehumidifier then prints will come out of superb quality till the end..also, bed adhesion is not very good...i have had to use to glue to make sure prints don't moveI would really love this if they included a reusable air tight plastic bag with the filament....coz i don't have anything to store it where it won't retain moisture.

I have glass bed... Sometimes not stick with bed (50*C) @ 65-70*C working fine but bottom surface not cameout smooth...

Not the same white shade as usual. Also keeps breaking while printing the same things I have succesfully printed several times before with the same G-code.

Good quality filament. Nice print quality and bed adhesion is also good.

This seemed like a good value for money. The prints came out well on the Ender 3. Overall the strength of the material seemed OK, but it is slightly harder than other fliment I have used. Because of that it broke a few times while loading the filament.The major problem I had with the filament was with winding, the filament got stuck a few times. I couldn't leave this in attended for printing.The adhesion is not great on glass surface.

I am writing this after using half of the spool in in Creality Ender 3.The filament is close to dimentional tolerance as specified, so no issues of clogging in nozzle. However, it is not smooth and had much minute bend, thats because care has not been taken while winding.The spool hole diameter is large than stock spool mounted of ender 3. This gives ocassional jerking motion while unwinding. I had filament break only 2 times till now which is quite normal so no regrets there.The advertised operational temperature is 190-230. However, good print quality is obtained at 190C.Bed adhesion is way too great, that j had difficult time to remove prints even in winter. However, reducing the temperature to 45C (ideal is 50C) works well.So far no issues in print quality, but still i had get more detailed prints usjng trial PLA filament sold with ender 3. The material is slight springy causing it to ozze out from the nozzle even after the extruder had stopped pushing. This creates. fuzzy smudged during long prints after each filament retrection.Overall for 1000 rupees not a deal breaker but not the best filament either. It is worth 4 star considering price and quality.

Pla is good but the roller inside little hard to roll any way it worthy