10pcs 0-24V MOSFET Button IRF520 Transistor Triode MOS Driver Module for Arduino MCU ARM Raspberry pi

Will be used for a LED Mars light project

So I wanted a simpler way to incorporate a MOSFET into my model rockets launchpad. Used one for solenoids and other for ignition. Simple to use and work every time.

Used it with a 3.3v logic teensy 4.1 to drive a 5V logic microsyepperdriver. Worked as expected, i like that it has an led that lights up when mosfet is on.

The units work very well with an Arduino or RPi source, and PWM signals work as expected. Unfortunately, they don't provide a schematic or wiring diagram, so it took me a bit of time to figure out how the thing works. Otherwise, it's great for the money.

I ordered 6 pack, and all of them worked. These are super easy to hook up and run. Perfect for what I needed. I will be buying more soon!

I used these to power 6V motors off of a 9V battery controlled by an Arduino Uno Rev3. This worked excellently. The Arduino used 5V logic and pulse width modulation controlled the motors speeds.Using a raspberry pi 4 with 3.3V logic these drivers were useless. Even using the full high 3.3V signal the driver would only let out enough current to dimly light an LED. It failed completely to turn on the 6V motors.

Product is awesome. It’s being used for my 12Volt RGB LED so that I can connect then to my 3-D printer and be able to monitor Temperature by just looking at the color of the enclosure. Blue for cold, red for hot, green for done, and white while in operation.

I don't know how they can say this works with 3V3 because that fet turns on at 4V.A waste of time, If you're hooking this into an RPI or anything that has a 3V3 IO level output.3