The installation of this product will require anywhere from 2 to 6 wiring connections depending on how you want to configure the system per your liking. We will provide precise directions with wire colors and locations in the manual and in additional info upon request. Please note: A person with a good basic knowledge of wiring 12 volt car electronics should be able to install this product successfully - Our remote starts are ONLY compatible with AUTOMATIC transmission vehicles. We also sell manual trans setups, Email for more info regarding those if interested. Wire ties and t-taps are also included to complete your installation. Preloaded module & T-Harness combo for 2013+ Mazda Push-to-Start vehicles. The EVO-MAZT1 is the ultimate Factory Fit, ALL-IN-ONE data immobilizer bypass, doorlock, alarm & remote start interface with T-Harness combo module for 2013+ Mazda vehicles. It raises the standard of hassle-free installation convenience to a whole new level. It uses a multiple bus architecture with 10 separate communication ports that provide more complete functionality on every supported vehicle.
E**C
Not true plug and play
Seller responds quickly, This kit is not truly plug and play! The ignition side is but, you still have to put t-taps on three wires. Why they dont make a harness like the ignition I don't understand because if would make this a true plug and play.With that said if you accept puncturing wire insulation with t-taps this kit does work very well.
P**O
Watch what Instructions you get, 2017 Ram 2500
So spending a good portion of my Sunday trying to get this unit to operate. Call Tech support Monday morning to talk with some arrogant ***** to find out they sent me the wrong wiring schematic (how many can there be for a single application)? Of course this was my fault some how according to the Tech? These guys are a joke, the instructions show what you need additional, diode, 5 amp fuse, resistor, so of course to do it correctly I get those items, hook all up and do it the right way (no scotch locks or wire taps, I solder them), Tech guy says none of those are needed? Now I have to undo my work to rewire it to the correct instructions? Then to say this is plug and play. I would pass.....Buy the Ram add on kit and pay the few extra bucks...... then again if you have a late 16 to present you already have auto start available just change your fobs, install the hood latch and have the dealer activate it..
Trustpilot
3 weeks ago
3 weeks ago
