Class III/IV 8-Position Adjustable Trailer Receiver Ball Mount with 2 Sets Pin&Clips for (GTW 6,000 lbs)

Value, quality, versatility.

Sturdy, tough, easy to use

Hitch is very solid and strong. Very loose fit, I made shims for the adj. ball mount and receiver. Very good product at a reasonable cost. Ended up returning, angled support interferes with use of anti-rattle hitch clamp that I like to use, even with shims. Also stick out quite a ways, I believe it was 13" from receiver end to ball.

Would like to have another part for another ball to attach to the unit. I’ve been trying to get one, but I don’t know where to get it.

I really like the range of different heights the hitch could be used at. There’s about a 6” difference between the height of my boat trailer and my utility trailer, and this adjustable hitch is perfect for that

Adds two hundred pounds to tongue weight. Ok, maybe not. Built very solid. I can't magnaflux the welds but they all look very well done. I've got a Kia Sorento that has a very low hitch height. Way too low for U Haul which expects roughly 18" ball height. I was able to get there without flipping it. Expect it to rattle a bit. Honestly, I'd be a little hesitant about maxing out class IV, but 500/5000Lb class III, no problem. The main piece that goes in your 2" receiver is hella stout and so is the ball section. My only concern (and this is speculation) is the piece that wraps around where the pins go through. I'm just towing a cycle trailer, so no worries.

Good value for the money. Seller shipped promptly.

It rusts and runs down the side due to no drainage hole at the bottom. I have my hitch standing straight up rather then down and it just looks bad when hooked up. It is a very solid unit and I added some dense foam padding in the gap large between the rail and the ball mount attachment. It rides very quiet. works well and makes leveling a trailer a breeze, love it and would recommend.

Good solid Hitch…bulky piece…it fitted a little sloppy in my Truck receiver so I added some thin rubber strips on each side to quiet it down otherwise it does the job and levels out the different size trailer Tows…

Arrived as expected and am using it for a Jeep Grand Cherokee that is much higher off the ground than my last vehicle, causing a significant tilt in my trailers. Appears very heavy duty. I'll probably bolt it on instead of using the pins as there are now 3 "wiggle" points as to the standard 1 on a regular hitch (the wiggling around of the hitch tends to make a lot of noise in the vehicle). One thing to watch - this hitch sits well away from the vehicle which has caused my trailer chains and wiring to not reach anymore. I'll have to extend both. Overall I'd recommend this hitch and I would buy it again.

je l approuve à 90% je le recommamde