VoodonalaCarbon Fiber Grain Dashboard Trim for 2015-2020 Ford F150 F250 F350 Super Duty

Look awesome, but the pieces that go along the dash for speedometer, rpms etc. They have a bit of a bend to them that don't quite line up right so one end along the bottom portion is starting to come up. Can't really tell too much but I may just take it off and run some super glue on it. That'll definitely make it stay put

I started by adding door pull covers because, when I bought my truck, the pulls were heavily scarred. I like the look so much that I have carried it over to my entire dash. I have read that the adhesion is poor but I have not found this to be the case. After cleaning the area to be covered, I remove the protective covers from the adhesion strips and heat them with a hair drier. Before applying the cover, I also heat the area the the cover is going on. Hold for a minute and I have had great success. Great and inexpensive way to class up a vehicle.

Looks Great, Priced right, good double sided tape, holds well. i am plaesed with this purchase.

I recently installed these items. I followed manufacturer instructions. The trim looks really good on my 2016 Ford F150. Better quality than expected and the fit was perfect with some pieces, and ok with others.1. Carbon fiber grain dashboard trim kit:At first, one of the corners of the 3 middle piece didn't want to stick. But I held it down for an extra 1-2 minutes and it stuck. It's been a week, and it's still sticking. This kit looks great.2. Carbon fiber grain window lift panel switch trim:This kit also looks good, especially the pieces for the two front doors. However, the rear window trim could have been shaped a little different to look better on my 2016 F150 XL. Not a show stopper, but could be better. See pictures.3. Carbon fiber steering wheel bezel kit:This also looks really good. However, the bottom of the steering wheel trim kit did not stick very well. So, I used extremely strong 3M sticky tape and that solved it. Looks great though.4. Side outlet ventsEDIT: I just put these on 1/9/2018. The fit and look great. No issues with them sticking. I cleaned the area, heated up the tape and pressed down for one minute.

The media could not be loaded. Very easy to install! Make sure to prep area by cleaning with at least a 70% alcohol solution. I recommend removing tape first when ready to install. Hold pressure firmly for at least 1 minute. If it doesn’t adhere then I recommend a drop of crazy glue!

Unfortunately, it did not fit my F-150. Returned it for a trim that does. Will see if I get a refund?

Great fit looks great!!! Easy install!!! Also purchased the steering wheel trim to match!

color is bright and deep .matched my red truck perfectly.great product!

Adds to the look of my truck and makes the cab interior pop

I have done my interior of my truck with all of these pieces. The dash one and the steering wheel are the only two that I wish were better. The gauge trim is a completely different material and colour from the rest of the products it’s more of an orange then the red that I have throughout the entire truck. The bottom piece doesn’t fit at all the mold is so out of shape it just pops off. Didn’t even bother putting it on cause even after adding more 3M two sided tape still keeps popping loose. Steer wheel piece is the smaller size on the right hand side and still shows the silver underneath.