Peerless SUF651 Ultra Slim Flat Wall Mount for 37 to 75-Inch TVs (Black)

buon prodotto, suggerisco l'acquisto.

Does just what the description on Amazon said (but back of TV must be FLAT or you need to adapt the spacers ( which are included) if, like my Panasonic LED/LCD your speakers bulge just half an inch behind the TV.Mounts easily and safely onto studs in wall if your TV is light enough.Instaling the security bar looks essential to me (and I had to tap the last few inches in with a hammer! So very secure.)Make sure you really don't want any tilt or any turn, and then this bracket is superbly thin.

Awesome mount. Super thin; you can't even see it. Works out great with a flat 65" LED TV like mine. Mounted it to my metal studs with 4 sheet metal screws and some washers and its able to hold up my 50lbs TV.Only downside is how the slider arm to lock the pegs in place works. I eventually got it to work with about a half hour of fiddling around.- the metal that the sliding arm is made out of easily bends and gets bent out of shape quickly when trying to shove it in- when the TV is mounted, it's hard to see if the metal arm is going in the right direction. I had to practice with the TV removed and used some tape to mark where the sliding arm would make contact with different parts of the mount.- for a 65" TV, the arm is barely long enough to be able to get my hand behind it to push with enough force. Again with too much force, the metal easily bends- with all the friction I had to push through, the arm stays in place even without screwing in the arm lock

Used this super thin wall mount on a Sony 75". TV is very thin, and this mount almost makes the "thinness" of my TV look even thinner/better on the wall. Hard to articulate, but its looks awesome. I was a little bit nervous to mount a 75 with only the top two bolts on the TV. The way it works is you use the two top holes on the back of the TV with the included bolts that then hang onto the wall plate, so there's no typical hardware that attaches to the TV, just bolts. So the bottom kind of just lays on the wall. The included locking bar slides over the notches so if you try to pick up the TV it wont allow it to come off the wall plate. Anyway I was nervous about just using two bolts, but I tested the mount and its solid. Just make sure its secure to the wall correctly. Measure before you do anything. Its so close to the wall you NEED to make sure everything will work the way you want it to. I mounted the TV then measured before any holes were made for cables that way there's room for running cables nicely. If you have an older TV with the power cable plug sticking out of the back, you need to get one of those flat cables where it attaches to the TV otherwise it wont work. Basically if you have any ports directly on the back of the TV it wont work. You need to have ports on the bottom of the side of the TV. Great low profile mount. Makes install look amazing. If you're replacing an existing mount and plan to use the same power and cable holes, plan it out first. you might have to go up or down on the TV. I'll add a picture when I get a chance.

Easy to install, ultra slim.