ECCPP AC Compressor Clutch Fit for Hyundai Santa Fe 2.7L 2001-2006

A Perfect Fit! My 2011 Jeep Wrangler happily now once again has air conditioning, thanks to this amazing part!

It was not as high quality as I would have liked, wire harness had smaller gauge wires that the original, but I guess that can be expected for an after market part. It installed easily and worked as it should. Good product for the price.

My compressor pressure plate cracked and was re spinning on my ac compressor, they're not cheap for my truck so I figured it's worth a shot to try a replacement. I bought 2 of these, it's not my first time setting up compressor clutches. First off it involves quite a bit of labor to get one of these set up depending on your application. My first one I had to use additional spacers to get it spaced appropriately. About 3 hours later I had my AC working, less than 30 minutes later it blew the fuse for the compressor clutch. I'm like, okay maybe there was an issue with the coil and it's just a one-off. So I order a second, it shows up, I disassemble the compressor again. The first coil had a melted bubble in the insulation , it was clearly shorted internally and that was the cause of the failure. So I assemble with the second clutch, of course the spacers that came with it were insufficient. Luckily I had the extras from the one that had already failed. Go through the set-up again. Install it again... And it's literally the same it ran for 15 minutes and blows the fuse. I'm so disappointed I wasted my time twice on this garbage product.

Good quality and fitment

This kit did fit perfectly but one small detail, the clutch plate was not an exact match yes it does work fine after installed but the front clutch plate is nearly perfectly flat no raised rubber grommets like what came off. Ok no worries it works. But this little detail makes it very difficult to tighten the little bolt on the front to torque specs with a special tool to fit in the whole that are on it. Where if it was oem I could use a simple screw driver to hold it to tighten that bold. Seems to work great. Had to get creative to tighten that little bolt other than that I would buy again

This AC clutch worked exceptionally well! I’ve had it installed in my truck for a month now, and it’s still performing flawlessly. The swap kit was perfectly sized and included everything I needed. However, finding a standalone AC clutch can be challenging because GM insists on replacing the entire compressor. Installing this clutch into my Colorado was a significant hassle. While I understand that GM’s design prioritizes the entire compressor assembly, it’s frustrating for customers who want to replace only the clutch. Despite the initial difficulties, the clutch is now back in place, and it operates incredibly quietly. The installation also looks great under the hood. Here are a few tips for anyone considering replacing this part on their Colorado: 1. Ensure you have a good set of snap ring pliers with a 90-degree and straight nose. 2. If you’re not planning to remove the compressor like I did, be prepared for a lot of patience and nimble fingers. 3. It’s important to note that there’s no way to check the gap with a feeler gauge. Make sure your gap is set correctly.

I had to put the numbers from the packaging into search and get the diagram because we couldn't figure out where the extra washers went but for our 2015 Chevy Colorado, it was a perfect fit! The quote we got to fix it was $2,500. A much better out come. I have uploaded the diagram for you

Absolute trash. I didn't need an entire new a/c compressor for my 2010 Mazda 5 2.3l, just the clutch as all the friction material was gone. The original OEM clutch lasted 15+ years, and I would have been satisfied if this one lasted a single year for the price. Installed the new ECCPP clutch, with some difficulty getting it to sit flush with the compressor body, and squared up with the compressor shaft. The bearing must have been installed incorrectly, or slightly out of alignment. 1 HOUR AFTER INSTALLING, THE CLUTCH TORE ITSELF TO PIECES. It burned itself up completely, with the bearing detonating like a grenade. Taking it off, it fell apart with the ball bearings falling out all over the garage floor. Worst of all, THE CLUTCH DESTROYED MY OEM ORIGINAL A/C COMPRESSOR. When removing the clutch, I found it had basically welded itself to the compressor shaft and snapped a chunk off the end. I cannot emphasize this enough, DO NOT BUY THIS A/C COMPRESSOR CLUTCH.

Buen producto facil de instalar

2014 Malibu. Clutch installed but didn’t work. The electro magnet and pulley were fine, but I had to reuse the old face plate in order for this to work. Very frustrating when you’ve already finished installing and then find out you have to remove and replace some parts.

Doesn't fit for crv it's defected and destroy the belt

Perfect replacement for my 2016 Cherokee trailhawk. Hardware was an exact match and seemed to be high quality. A/c is blowing cold again!

Product arrived in perfect shape and no issues. I gave it a 5 star rating based on initial impression and that the product is a replacement for worn parts on my current vehicle. I am not yet confident of the product's expected longevity and so I will update my ratings in future based on the quality of the product and if it lasts as long as other north american built aftermarket products.